Abstract:Bamboo-concrete composite (BCC) beams are newly-innovated products used for floor system which synergistically utilizes bamboo and concrete components. These composite beams at cur-rent technology belong to the beam characterized with partial composite action due to the ex-istence of relative slip between bamboo segment and concrete slab. Existing investigations have demonstrated that the load bearing capacity of BCC beams depends on their bending stiffness; however, very limited prediction models are available to accurately estimate the bending stiffness of BCC beams. At present, the bending stiffness of BCC beams is predicted with the help of gamma-method in Eurocode 5-Part 1-1, and available studies have demonstrated that this method overestimates the bending stiffness of BCC beams. To this end, this paper presents a novel explicit model characterized with mechanism and data mining to predict the bending stiffness of BCC beams under short-term loads. Three steps were performed to achieve the aforementioned research objective. The first step was to introduce the axial force transfer coefficient into the equilibrium equations of internal force for bamboo segment and concrete slab. Secondly, the bending stiffness of BCC beams was established by taking into account the effect of relative slip with the help of existing experimental results from the interfacial shear test and flexural test. Finally, the proposed model was validated by comparing with flexural performance results of BCC beams collected from available literature as well as those obtained from gamma-method. The comparative results show that: i) the predicted bending stiffness of BCC beams is much closer to tested ones compared with gamma-method; ii) the errors of proposed model predicting the bending stiffness for most BCC beams are within 10% of test results; however, nearly half of the predicted ones using gamma-method have errors exceeding 10% of test results, both of which verify that the mechanism and data mining-dual driven model receives a better prediction for short-term bending stiffness of BCC beams.

Low Velocity Flexural Impact Behaviors of Bamboo Fiber Reinforced Composite Beams

Impact Testing of Reinforced Concrete Beams Shear-Strengthened with Fiber-Reinforced Polymer Wraps

Dynamic Behavior of CFRP-Strengthened Reinforced Concrete Beams Without Stirrups under Impact Loading

Impact Bending Behaviors of Parallel Bamboo Strand Lumber Beams: Velocity Sensitivity and Anisotropy

High-strain Rate Compressive Behavior of Douglas Fir and Glubam

Bending Stiffness of Bamboo-Concrete Composite (BCC) Beams under Short-Term Loads

Flexural behavior of carbon fiber-reinforced concrete beams under impact loading

Impact Performance of Two Bamboo-Based Laminated Composites

Flexural Failure Mechanism of Bamboo Composite Plates with Different Construction Technologies and Tectonic Patterns

Progressive Failure and Energy Absorption of Chopped Bamboo Fiber Reinforced Polybenzoxazine Composite under Impact Loadings

Flexural Behavior of Hybrid Composite Beams with a Bamboo Layer and Lattice Ribs

Experimental and numerical investigations on the dynamic response of woven carbon fiber reinforced thick composite laminates under low-velocity impact

Experimental Evaluation of Low Velocity Impact Properties and Damage Progression on Bamboo/Glass Hybrid Composites Subjected to Different Impact Energy Levels

The behaviour of thermoplastic and thermoset carbon fibre composites subjected to low-velocity and high-velocity impact

Simulation and Experiment on the Low-Velocity Impact Response of Flax Fabric Reinforced Composites

Flexural property of steel reinforced bamboo scrimber composite beam

Dynamic Behavior of Woven Composite Beams under HPB Impact Loading

Low-Velocity Impact Load Testing of RC Beams Strengthened in Flexure with Bonded FRP Sheets

Low-Velocity Impact Behavior and Damage Characteristics of CFRP Laminates

Flexural mechanical properties of H-shaped steel-bamboo scrimber composite beams

In-plane compression response of woven CFRP composite after low-velocity impact: Modelling and experiment