Abstract:In this article, two coplanar-strip (CPS) wideband balanced bandpass filters with intrinsic common-mode (CM) suppression are proposed based on shunt-stub structures. As previously reported with higher integration and greater flexibility, the double-sided shunt-stub structures could make sufficient use of various transmission lines (TLs), such as double-sided parallel-strip line (DSPSL), microstrip line (MSL), and slot line (SL). Compared with its conventional dual circuit, the proposed structure herein is capable of realizing ideal CPS-based resonant characteristics without degraded performance. As such, a DSPSL-loaded CPS triple-mode resonator and a microstrip-to-CPS (MS-to-CPS) transition are developed as two distinctive double-sided shunt-stub element units. Meanwhile, their equivalent circuit models are generalized for analysis of these proposed shunt-stub units and the corresponding synthesis design is further theoretically derived. For experimental verification, one fifth-order and one seventh-order balanced filters are designed, fabricated, and measured. It has been well demonstrated that both the wideband differential-mode (DM) filtering property and intrinsic CM suppression are satisfactorily achieved at the same time, with a certain range of available bandwidths.

Common-Mode Noise Absorption Circuit Using Double-Sided Parallel-Strip Line

Wideband Balanced Bandpass Filter with Common-Mode Noise Absorption Using Double-Sided Parallel-Strip Line

An Analysis and Implementation of Common Mode Feedback in High-Speed Fully Differential Op-Amp

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

A Compact Meander Line-Resonator Hybrid Structure for Wideband Common-Mode Suppression

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

Design of Absorptive Common-Mode Filters Based on Coupled Stripline λ/4 Resonator

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

Modeling And Measurement Of A Common-Mode Filter Based On The 3-D Transmission Line Structure

A Novel Compact Dual-Functional Circuit With Differential-Mode Equalization and Broadband Common-Mode Suppression Using Patterned Ground Plane

A Common-Mode Noise Suppression Filter for Gigahertz Differential Signals Based on Substrate Integrated Waveguide Resonators

A Wideband Common-Mode Noise Filter for Differential Signals Using Coplanar Waveguide Quarter-Wavelength Resonators

Wideband Single-Ended-to-Balanced Power Divider with Intrinsic Common-Mode Suppression

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

An Alternating High‐low Impedance Common‐mode Filter for Differential Striplines

A Compact Common-Mode Suppression Filter for Differential Signal Transmission with Slow-Wave Structure

A novel wideband common-mode suppression filter for differential signal transmission

Wideband Balanced Filters With Intrinsic Common-Mode Suppression Using Coplanar Strip Double-Sided Shunt-Stub Structures

An Asymmetric Spiral-Shaped Dgs Optimized by Genetic Algorithm for Wideband Common-Mode Suppression

A Novel Coplanar Common-Mode Filter with A Wide Stopband

Suppressing Method of Common-Mode Noise in MHz 380V-12V DCX Converter