Abstract:Mg-Al-Sn alloys are being developed as a new series of magnesium alloys due to their good creep resistance, ductility and high temperature properties. The Mg-Al-Sn alloys containing low Al/Sn-content may have potential as a high-ductility wrought magnesium alloy. However, the effect of composition on the microstructure and mechanical properties of wrought Mg-xAl-ySn alloys have received little attention. In the present work, Mg-xAl-ySn-0.3Mn (x = 1, 3, 6 and y = 1, 3) alloys have been prepared by hot extrusion at temperatures from 523 K to 623 K. The experimental results reveal that the yield strength of the as-extruded alloys is sensitive to Al content and extrusion temperature, but insensitive to Sn content. The yield strength increases with decrease Al content or extrusion temperatures. The Mg-1Al-ySn-0.3Mn (y = 1, 3) alloys extruded at the temperatures <= 573 K exhibit the relative higher yield strength in this paper (the yield strength exceed 250 MPa with elongation of about 20%). The relative high strength is mainly attributed to the formation of fine recrystallized grains and high fraction of coarse un-recrystallized grain regions which show strong (10-10) and (0001) textures. The orientation relationship between the precipitated Al8Mn5 phase and the Mg matrix in the Mg-1Al-1Sn-0.3Mn alloy is also determined. And the strengthening mechanism of the alloys is discussed. (C) 2015 Elsevier B.V. All rights reserved.

Microstructure and mechanical properties of as-cast and extruded Mg-8Li-1Al-0.5Sn alloy

Microstructure and Mechanical Properties of As-Cast and Extruded Mg-8Li-3Al-0.7Si Alloy

Microstructure and Mechanical Properties of Mg–6Li–xAl–0.8Sn Alloys

Microstructure and Mechanical Properties of As-Cast and Extruded Mg–8Li–3Al–2Zn–0.5Nd Alloy

Microstructure and Mechanical Behavior of Mg-0.5Si-xSn Alloys

Microstructure and Strengthening Mechanism of Hot-Extruded Ultralight Mg-Li-Al-Sn Alloys with High Strength

Microstructure And Mechanical Properties Of Mg-8li-4al-0.3y Alloys

Microstructure and mechanical properties of Mg–8Li–xAl–0.5Ca alloys

Microstructure and Mechanical Properties of Selective Laser Melted Mg-9 Wt%al Powder Mixture

Microstructure and Mechanical Behavior of Mg–10Li–3Al–2.5Sr Alloy

Microstructure and Mechanical Properties of as-Cast Mg-Li-Al-xSi Alloys

Effect of Sn content on microstructure and tensile properties of as-cast and as-extruded Mg−8Li−3Al−(1,2,3)Sn alloys

Microstructure and Mechanical Properties of Mg–Al–Sn Extruded Alloys

Microstructures and mechanical properties of as-extruded Mg–5Sn–1Zn–xAl (x=1, 3 and 5) alloys

Microstructure and Mechanical Behavior of As‐Cast, Extruded and Nanocrystalline Mg‐9Li‐3Al‐2.5Sr Alloy

Tailoring the Microstructure, Mechanical Properties and Damping Capacities of Mg–4Li–3Al–0.3Mn Alloy Via Hot Extrusion

Microstructure and Mechanical Properties of Asextruded Mg–xAl–5Sn–0·3Mn Alloys (x = 1, 3, 6 and 9)

Microstructures and Mechanical Properties of Hot-extruded Mg-6Zn-xCu-0.6Zr(x=0,0.5,1.0,1.5) Alloys

Solidification Microstructure and Mechanical Properties of Cast Magnesium-Aluminum-Tin Alloys

Microstructures and Mechanical Properties of As-Cast and As-Extruded Mg-4.50zn-1.13ca (wt%) Alloys

Microstructure And Mechanical Properties Of Duplex Structured Mg-Li-Zn-Y Alloys