Abstract:Recent high-tech applications of ultralightweight close-celled aluminum foams require a tighter control of their pore morphologies. To this end, the progress made during the past ten years in this field is systematically summarized. Inherent relationships amongst pore size, porosity and pore shape are explored, key steps of pore structure control and their cross-relations are determined, and a general framework of processing steps and techniques affecting pore structure control during the foaming process of molten aluminum is established. Built upon this framework, the relationships of three key control parameters (pore size, porosity, pore shape) with industrial applications, fabrication technologies and processing methods are systematically addressed. It is demonstrated that the evolution of cellular structure is influenced by many processing factors such as viscosity, foaming time and solidification mode. This makes the foaming and solidification processes extremely complicated, leading to difficulties in pore structure control. To obtain pure aluminum foams having high porosity, it needs not only to precisely control the porosity making use of the relationship between porosity and foaming time, but also to solidify in time during the plateau stage on the porosity-time curve to control the pore size and uniformity of pore distribution. To obtain aluminum alloy foams, in addition to the steps mentioned above, multidirectional solidification is also needed in order to overcome the shrinkage caused by the additional force field during cooling. For high strength aluminum alloy foams having spherical pores and relatively low porosities, a suitable amount of vesicant (about 1.0%) and proper stirring time (about 100 seconds) are required in order to drop the plateau stage of porosity-time curve to low porosity regime. Faced with new high-tech needs, the novel method of two steps foaming has more advantages and potentials over other technologies to fabricate unconventionally shaped components and large-sized multifunctional panels.

Fabrication of high-porosity open-cell aluminum foam via high-temperature deformation of CaCl<sub>2</sub> space-holders

Fabrication of high-porosity open-cell aluminum foam via high-temperature deformation of CaCl2 space-holders

Fabrication and Compressive Behavior of Open-Cell Aluminum Foams Via Infiltration Casting Using Spherical CaCl2 Space-Holders

Preparation and Compression Behavior of High Porosity, Microporous Open-Cell Al Foam Using Supergravity Infiltration Method

Pore Structure and Compressive Properties of Open-Cell Aluminum Foams Prepared by Infiltration Casting Based on NaCl Space-Holder

Manufacturing of open-cell aluminum foams via infiltration casting in super-gravity fields and mechanical properties

Effect of Precursor Design on Preparing Open-Cell Aluminum Foam Fabricated by Space-Holder Method

Study on Deformation of Closed-Cell Aluminum Foam in Different Solid–Liquid–Gas Coexisting State

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Fabrication, Structure and Property of Copper Foam

Processing of CuAlMn Shape Memory Foams with Open Spherical Pores by Silica-Gel Beads Infiltration Method

Preparation of Big Size Open-Cell Aluminum Foam Board Using Infiltration Casting

Control of Pore Morphology in Close-Celled Aluminum Foams

Investigation of Thermal Conditions of Porous Aluminum Formation

Shape Formation of Closed-Cell Aluminum Foam in Solid–liquid–gas Coexisting State

Fabrication of Uniform and Rounded Closed-Cell Aluminum Foams Using Novel Foamable Precursor Particles (FPPs)

Precise Fabrication of Open Porous Mg Scaffolds Using NaCl Templates: Relationship Between Space Holder Particles, Pore Characteristics and Mechanical Behavior

Preparation of Aluminum Foam by Gas Injection Foaming

Numerical Simulation of Aluminum Foams by Space Holder Infiltration

Preparation of Shaped Aluminum Foam Parts by Investment Casting

Investigation on the Structural and Mechanical Properties of Al Foam Manufactured by Spark Plasma Sintering and Compression Molding Methods