Abstract:Aluminum foam is a lightweight material and has excellent shock-absorbing properties. Various properties of aluminum foam can be obtained by changing the base aluminum alloy. Multi-layer aluminum foam can be fabricated by varying the alloy type of the base aluminum alloy, but with different foaming temperatures, within a single aluminum foam to achieve multiple properties. In this study, we attempted to fabricate a two-layer aluminum foam with the upper layer of a commercially pure aluminum A1050 foam and the lower layer of an Al-Si-Cu aluminum alloy ADC12 foam by using an optical heating device that can heat from both the upper and lower sides. Two types of heating methods were investigated. One is to directly stack the A1050 precursor coated with black toner on top of the ADC12 precursor and to foam it from the top and bottom by optical heating. The other is to place a wire mesh between the ADC12 precursor and the A1050 precursor and place the A1050 precursor on the wire mesh, thereby creating a space between the precursors, which is then foamed by optical heating from the top and bottom. It was shown that both precursors can be foamed and joined, and a two-layer A1050/ADC12 foam can be fabricated for both types of heating methods. In the method in which two precursors were stacked and foamed, even if the light intensity of the halogen lamps on the top and bottom were adjusted, heat conduction occurred between the stacked precursors, and the foaming of each precursor could not be controlled, resulting in tilting of the joining interface. In the method of foaming using a wire mesh with a gap between two precursors, it was found that by adjusting the light intensity, the two precursors can be foamed almost simultaneously and achieve similar pore structures. The joining interface can also be maintained horizontally.

Preparation of Shaped Aluminum Foam Parts by Investment Casting

Preparation of complex shaped aluminum foam by a novel casting-foaming method

Mesostructural Design and Manufacturing of Open-Pore Metal Foams by Investment Casting

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Foaming Process and Properties of 6063 Aluminum Foams by Melt Foaming Method

Investigation of a Template‐Based Process Chain for Investment Casting of Open‐Cell Metal Foams

Preparation of Aluminum Foam by Gas Injection Foaming

Foaming Behavior of Microsized Aluminum Foam Using Hot Rolling Precursor

Preparation Technology of Aluminum Foam Sandwich Panels by Powder Metallurgy and Optimization of Cellular Structure

Research on Key Technologies for Batch Preparation of Aluminum Foam Slabs by Melt Foaming Process

Development of AlMg35-TiH2 composite foaming agent and fabrication of small pore size aluminium foams

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Fabrication of Two-Layer Aluminum Foam Consisting of Dissimilar Aluminum Alloys Using Optical Heating

Properties of Aluminum Foam Prepared by Gas Injection Method

Fabrication of Uniform and Rounded Closed-Cell Aluminum Foams Using Novel Foamable Precursor Particles (FPPs)

Numerical Simulation of Lost-Foam Casting for Key Components of A356 Aluminum Alloy in New Energy Vehicles

Shape Formation of Closed-Cell Aluminum Foam in Solid–liquid–gas Coexisting State

Preparation and Compressive Performance of an A356 Matrix Syntactic Foam

Study on an Aluminum Foam by Gas Injection Foaming

A Novel Hot-Pressing Method to Prepare Foamable Precursor of Aluminum Foam Sandwich (AFS)