Abstract:Aluminum foam that is lightweight with high specific strength, high energy absorption and other characteristics can be used in aerospace, transportation, machinery manufacturing and other fields. The PCM method is usually used to prepare closed-cell aluminum foams. The microsized aluminum foams made by this process can solve the non-uniform pore structures caused by liquid drainage during the foaming process of large aluminum foams. The surface morphology and internal pore structure of microsized aluminum foams are affected by the quality of the precursor used for foaming. In this paper, foamable precursors were obtained via either hot rolling or hot extrusion and subsequently foamed. By analyzing the micromorphology and foaming process of the precursor, the influence of the technological method on the macroscopic pore structure of the final aluminum foam was studied. The results show that the aluminum powder particles in the precursor prepared with the hot rolling method had metallurgical bonding, and the outer surface was dense, with almost no porosity and holes in the interior. The microsized aluminum foam obtained after foaming was smooth in appearance, and the internal pore structure was round and uniform. The reason is that during the foaming process of microsize aluminum foam, the foaming agent was evenly distributed in the precursor of the hot rolling process because of its compact structure. During the foaming process, the decomposed gas of the foaming agent will not escape, and the evenly distributed foaming agent tends to nucleate in situ. In the process of rapid foaming, the pressure in the bubble is enough to resist the liquid drainage phenomenon caused by gravity, and the growth direction of the gas core is isotropic, which promotes the foam structure to be more rounded and uniform.

Preparation Technology of Aluminum Foam Sandwich Panels by Powder Metallurgy and Optimization of Cellular Structure

Optimization of Cellular Structure of Aluminum Foams Produced by Powder Metallurgy Method

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Microstructural characteristics and mechanical properties of 7075 aluminum alloy foam sandwich panels fabricated via integrated forming and foaming

Foaming Behavior of Microsized Aluminum Foam Using Hot Rolling Precursor

Preparation of aluminum foam sandwich with metallurgical bonding using friction stir welding

Preparation of Al foam sandwiches and analysis of the interface microstructure

Research on Key Technologies for Batch Preparation of Aluminum Foam Slabs by Melt Foaming Process

Preparation and Compressive Performance of an A356 Matrix Syntactic Foam

Preparation principle and compression properties of cellular Mg–Al–Zn alloy foams fabricated by the gas release reaction powder metallurgy approach

Preparation of Aluminum Foam by Gas Injection Foaming

Fabrication of Mg-Al Alloy Foam with Close-Cell Structure by Powder Metallurgy Approach and Its Mechanical Properties

A Novel Hot-Pressing Method to Prepare Foamable Precursor of Aluminum Foam Sandwich (AFS)

Interface structure and bonding strength of metallurgical bonded aluminum foam sandwich (AFS) fabricated by hot-pressing

Effect of Cu and Sn Additions on the Cellular Structure of Al–Si–Mg Alloys Foaming at Low Temperature (≤600 °C)

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Study on the Process of Preparing Aluminum Foam Sandwich Panel Precursor by Friction Stir Welding

The Influences of Process Parameters on the Preparation of Closed-cell Aluminum foam by Friction Stir Processing

Effects of Aluminum Foam Filling on Compressive Strength and Energy Absorption of Metallic Y-Shape Cored Sandwich Panel

Preparation Technology and Application Status of Foam Aluminum Material