Abstract:The aluminum foam sandwich (AFS), which perfectly combines the excellent merits of an aluminum foam core and face sheet materials, has extensive and reliable applications in many fields, such as aerospace, military equipment, transportation, and so on. Adhesive bonding is one of the most widely used methods to produce AFS due to its general applicability, simple process, and low cost, however, the bonding interface is known as the weak link and may cause a serious accident. To overcome the shortcomings of a bonded AFS interface, short carbon fiber as a reinforcement phase was introduced to epoxy resin to reinforce the interface adhesion strength of AFS. Single lap shear tests and three-point bending tests were conducted to study the mechanical behavior of the reinforced interface and AFS, respectively. The failure mechanism was studied through a macro- and microanalysis. The result showed that after the reinforcement of carbon fiber, the tangential shear strength of the interface increased by 73.65%. The effective displacement of AFS prepared by the reinforced epoxy resin is 125.95% more than the AFS prepared by the unreinforced epoxy resin. The flexure behavior of the reinforced AFS can be compared with AFS made through a metallurgical method. Three categories of reinforcement mechanisms were discovered: (a) the pull off and pull mechanism: when the modified carbon fiber performed as the bridge, the bonding strength improved because of the pull off and pull out of fibers; (b) adhesion effect: the carbon fiber gathered in the hole edge resulted in epoxy resins being gathered in there too, which increased the effective bonding area of the interface; (c) mechanical self-locking effect: the carbon fiber enhanced the adhesive filling performance of aluminum foam holes, which improved the mechanical self-locking effect of the bonding interface.

Interface structure and bonding strength of metallurgical bonded aluminum foam sandwich (AFS) fabricated by hot-pressing

Preparation of Al foam sandwiches and analysis of the interface microstructure

Fabrication and Interfacial Characterization of Aluminum Foam Sandwich Via Fluxless Soldering with Surface Abrasion

A Novel Hot-Pressing Method to Prepare Foamable Precursor of Aluminum Foam Sandwich (AFS)

Preparation of aluminum foam sandwich with metallurgical bonding using friction stir welding

Interfacial Behavior and Mechanical Properties of Aluminum Foam Joint Fabricated by Surface Self-Abrasion Fluxless Soldering

Microstructural characteristics and mechanical properties of 7075 aluminum alloy foam sandwich panels fabricated via integrated forming and foaming

Study on aluminum foam sandwich welding by friction stir welding technology

Preparation Technology of Aluminum Foam Sandwich Panels by Powder Metallurgy and Optimization of Cellular Structure

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Study on the Process of Preparing Aluminum Foam Sandwich Panel Precursor by Friction Stir Welding

The Mechanical Behavior and Enhancement Mechanism of Short Carbon Fiber Reinforced AFS Interface

Investigation of the Indentation Resistance of Aluminum Foam Sandwich Panels with Metallurgical Bonding Interfaces under Low-Velocity Impact

Compression performances of integral-forming aluminum foam sandwich

A Preliminary Study on Adhesion on Steel Cylinder Filled with Aluminum Foam

Influence of surface pretreatment on the bonding mechanism and mechanical properties of AA5052/CFRP friction stir spot welded joint

Novel method of fluxless soldering with self-abrasion for fabricating aluminum foam sandwich

Preparation and Compressive Performance of an A356 Matrix Syntactic Foam

Comprehensive Understanding of the Mechanical Properties and Microstructure Evolution of Aluminum Alloy/steel Laminates During Friction Stir-Assisted Incremental Forming with Synchronous Bonding Process

Deformation-free Manufacturing Al Alloy Laminated Structures by an Ultrasonic-Assisted Diffusion Bonding

The Influences of Process Parameters on the Preparation of Closed-cell Aluminum foam by Friction Stir Processing