Abstract:Electroless plating facilitates the metallization of nonconductive substrate surfaces, and of note, the precise control of the bath stability constant influences the deposition process of metal particles. In this paper, trisodium citrate, potassium sodium tartrate, nitrogen triacetic acid, thiourea, and ethylenediamine tetraacetic acid disodium were selected as coordination agents, and the effect of the metal ion ligand stability constant on the reduction deposition was studied. Coordination bonds can be established between the Cu2+ and O/N/S particles in the ligand because paired electrons in O/N/S hybrid orbitals tend to occupy empty Cu2+ hybrid orbitals and establish coordination bonds. More importantly, the copper-potassium sodium tartrate ligand exhibits the lowest stability constant and lowest reduction barrier. As an exception, a consecutive Cu-plated coating with an excellent crystallinity property was deposited on the cotton surface when potassium sodium tartrate was used as the coordination agent in the plating solution. The deposition amounts are 55.2% and 74.1% after 1 and 4 h of electroless copper plating, respectively. The surface resistivity of Cu-plated cotton is 0.38 Ω/cm2, and additionally, the surface resistivity ratio before and after 1000 cycles fluctuated between 0.9 and 1.1, indicating that the Cu-plated cotton exhibits outstanding flexibility. In this paper, the deposition rate can be optimized by adjusting the copper particle ligand stability constant in the plating solution, aiming to achieve optimal results.

Metallization of a LTCC substrate by electroless copper plating

Research Of Electroplating Cu On Pretreatment Ceramic Substrates

The Effect of Pretreatment on Adhesive Strength of Cu-plated Liquid Crystal Polymer (LCP)

Electroless And Eletroplating Copper On Liquid Crystal Polymer (Lcp) For High Frequency Applications

Laser-induced surface activation of LTCC materials for chemical metallization

Metallization of SMD Inductor of Ferrite Ceramics by Magnetron Sputtering

Research of LTCC/Cu, Ag Multilayer Substrate in Microelectronic Packaging

Cu Metallization of LTCC Substrate by Co-Firing Process in N2 Atmosphere

Effect of Electroless Plating Ni–Cu–P Layer on the Wettability Between Cemented Carbides and Soldering Tins

Experiment Study of Laser Thermal Enhanced Electrochemical Deposition

Influence of the Low-Pressure Cold Spray Operation Parameters on Coating Properties in Metallization of Ceramic Substrates Using Copper and Aluminum Composite Powder

Selective metallization of alumina ceramics by inkjet printing combined with electroless copper plating

Rationally design of substrate surface topography toward the improvement of Cu-plated coating adhesion

Effects of initial Cu grain size and impurity residues on the liquid phase reactions between molten solder and electroplated Cu

Electroless Copper Plating on a Cotton Surface: Effect of Metal Ion Ligand Stability Constant on Reduction Deposition

Growth mechanism and thermal behavior of electroless Cu plating on short carbon fibers

Electroless Plating of Copper on Al2o3 and Its Heat Treatment Behaviour

Effects of laser surface modification on the adhesion strength and fracture mechanism of electroless-plated coatings

Research on Copper Circuit Metalization of LTCC in N2 Atmosphere

A Facile Process to Manufacture High Performance Copper Layer on Ceramic Material Via Biomimetic Modification and Electroless Plating

Effects of Fe(III) and Cu(I) on Electrodeposition and Microstructure Characterization for Acid Plating Bath