Abstract:TiO2 nanocrystallines with a size of 3–7 nm have been synthesized by the sol–gel method with excessive water at a low temperature of about 50°C. The effects of amount of water and pH on the formation of sols and powders containing TiO2 nanocrystallines were investigated by X‐ray powder diffraction (XRD), transmission electron microscopy, and high‐resolution transmission electron microscopy. The results showed that a pure anatase phase was formed at pH 1, in contrast to the formation of particles with a mixture of anatase and brookite phases at pH 2–7. Moreover, at pH 1, the intensity of the XRD peaks and the crystal size increased with increasing water content when the water ratio increased from 40 to 100. Whereas the crystal intensity remained invariant, the crystal size still increased when the water ratio increased from 100 to 400. The photocatalytic activity was also investigated. It was shown that when the water ratio was below 100, the photocatalytic activity increased with increasing water content. Further increase of the water content decreased the photocatalytic activity. The photocatalytic activity decreased with increasing pH. All samples with pH=1 showed better photocatalytic activity than Degussa P25. Mechanisms for the formation of the TiO2 nanocrystalline particles at such a low temperature were also discussed.

Synthesis of Tin Oxide Nanoparticles by Precipitation Process: Effects of pH and Temperature on the Particle Size and Morphology

Influence of temperature on preparation of TiO2 nanoparticles by adsorption phase nanoreactor technique

pH control on preparation of nano-TiO_2 by gel-sol process

Effects of Water Amount and Ph on the Crystal Behavior of a TiO2 Nanocrystalline Derived from a Sol–Gel Process at a Low Temperature

Effects of Temperature on Indium Tin Oxide Particles Synthesized by Co-Precipitation

Synthesis of Tin Oxide Nanoparticles by Mechanochemical Reaction

Synthesis of Nanocrystalline SnO2 Powders with Oxidation of Granulated Tin-hydrothermal Method

Room-Temperature Synthesis of BaTiO<sub>3</sub>Nanoparticles in Large Batches

Hydrothermal Synthesis of Tin Oxide Nanoparticles

Effects of pH value and calcining temperature on indium tin oxide nanopowder synthesized by co-precipitation

Preparation and Properties of Nano-Sized Sno2 Powder

EFFECT OF TEMPERATURE ON TiO_2 NANOPOWDERS PREPARED BY A HYDROTHERMAL METHOD

Influences of Antimony Concentration on Nanometer-sized Tin Dioxide Powders

Low Temperature Synthesis of PbTiO<sub>3</sub> Nanoparticles

Preparation and Characterization of Nanometer TiO2 by Hydrolysis Precipitation Method

Synthesis and Characterization of Nanocrystalline Tin Oxide by Sol–gel Method

Synthesis of Tin Oxide Nanoparticles by Impinging Stream Reaction

Influence of Preparing Condition on Characteristics and Electronic Property of Nanometer-sized Antimony Tin Oxide Powders by Hydrothermal Method

Hydrothermal synthesis of nanosized SnO2

Analysis of the Particle Size and Morphology of Tin Powder Synthesized by the Electrolytic Method

SYNTHESIS OF NANOCRYSTALLINE SnO2 BY PRECIPITATION