Abstract:Photocatalytic activity of anatase TiO2 that increases with the increase of its synthesis temperature has been widely reported, but the reason for that remains incompletely understood. In this work, the positive effect of synthesis temperature, presumably due to the growth of particle size, has been examined. Three series of anatase samples with various particle sizes were prepared from the hydrolysis of TiOSO4 in water at 150 degrees C, followed by calcinations in air. The particle size of TiO2, estimated by X-ray diffraction and N-2 adsorption, increased with the increase of the hydrothermal time, calcination time, and calcination temperature. For phenol photodegradation in aerated aqueous suspension, three series of the catalysts showed different correlation between the activity and particle size of TiO2. However, with the same amount of Ag+ adsorbed on the oxide surface for phenol photodegradation in a N-2-purged aqueous suspension, those catalysts showed activities all increasing with the particle size of TiO2, whereas at given particle size, the thermally treated TiO2 was much more active than the hydrothermally treated one. These observations are discussed in terms of the solid crystallinity, surface area, exposed facets, surface hydroxyl groups, and light absorption. But, there only appears a positive correlation between the particle size, calcination temperature, and the number of surface defects, as revealed by photoluminescence spectroscopy. The increase of surface defects may facilitate separation of the photogenerated charges, consequently improving the efficiency for phenol degradation at the solid-liquid interface.

Hydrothermal Synthesis of Titania Powder with Different Particle Sizes

Controllable hydrothermal synthesis, optical and photocatalytic properties of TiO 2 nanostructures

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

Direct Continuous Hydrothermal Synthesis of High Surface Area Nanosized Titania

Preparation of Anatase-Type TiO_2 Nanoparticals from Ti (SO4)2 Solution under Hydrothermal Conditions and Its Photocatalytic Performance

A study on the synthesis of coarse TiO2 powder with controlled particle sizes and morphology via hydrolysis

Synthesis of Tin Oxide Nanoparticles by Precipitation Process: Effects of pH and Temperature on the Particle Size and Morphology

pH control on preparation of nano-TiO_2 by gel-sol process

Template-free Hydrothermal Synthesis of Macroporous TiO2 Microspheres on a Large Scale

Hydrothermal Preparation of Uniform Nanosize Rutile and Anatase Particles

Size-controlled synthesis of BaTiO3 nanocrystals via a hydrothermal route

Hydrothermal Preparation and Photocatalytic Properties of Quantum Size TiO2 Nanoparticles

Effects of Water Amount and Ph on the Crystal Behavior of a TiO2 Nanocrystalline Derived from a Sol–Gel Process at a Low Temperature

Influence of solution concentration on the hydrothermal preparation of titania crystallites

Effect of Key Parameters on the Morphology Transformation of Three-Dimensional TiO2 Solid Microspheres

Synthesis of Size-Controlled Nanotitania Particles via a Simple Sol-Gel Method

Facile and large-scale synthesis of hollow TiO2 nanostructures from TiCl3 solution

Hydrothermal growth of multi-facet anatase spheres

Synthesis of titanium dioxide nano-powder via sol–gel method at ambient temperature

Alkaline hydrothermal synthesis of homogeneous titania microspheres with urchin-like nanoarchitectures for dye effluent treatments.

Larger Effect of Sintering Temperature Than Particle Size on the Photocatalytic Activity of Anatase Tio2