Abstract:In recent years, researchers have focused on structural health monitoring (SHM) and damage detection techniques using nonlinear vibration and nonlinear ultrasonic methods. Fatigue cracks may exhibit contact acoustic nonlinearity (CAN) with distinctive features such as superharmonics and subharmonics in the power spectrum of the sensing signals. However, challenges have been noticed in the practical applications of the harmonic methods. For instance, superharmonics can also be generated by the piezoelectric transducers and the electronic equipment; super/subharmonics may also stem from the nonlinear boundary conditions such as structural fixtures and joints. It is hard to tell whether the nonlinear features come from the structural damage or the intrinsic nonlinear boundary conditions. The objective of this paper is to demonstrate the application of nonlinear ultrasonic subharmonic method for detecting fatigue cracks with nonlinear boundary conditions. The fatigue crack was qualitatively modeled as a single-degree-of-freedom (SDOF) system with non-classical hysteretic nonlinear interface forces at both sides of the crack surfaces. The threshold of subharmonic generation was studied, and the influence of crack interface parameters on the subharmonic resonance condition was investigated. The different threshold behaviors between the nonlinear boundary condition and the fatigue crack was found, which can be used to distinguish the source of nonlinear subharmonic features. To evaluate the proposed method, experiments of an aluminum plate with a fatigue crack were conducted to quantitatively verify the subharmonic resonance range. Two surface-bonded piezoelectric transducers were used to generate and receive ultrasonic wave signals. The fatigue damage was characterized in terms of a subharmonic damage index. The experimental results demonstrated that the subharmonic component of the sensing signal can be used to detect the fatigue crack and further distinguish it from inherent nonlinear boundary conditions.

Experimental Characterization of Sulfate Damage of Concrete Based on the Harmonic Wave Modulation Technique

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

The changes of the nonclassical nonlinear effect under erosion of sulfate

Monitoring of Concrete Structure Damage Caused by Sulfate Attack with the Use of Embedded Piezoelectric Transducers

Nondestructive Assessment of Microcracks Detection in Cementitious Materials Based on Nonlinear Ultrasonic Modulation Technique

Concrete damage diagnosed using the non-classical nonlinear acoustic method

Damage Mechanism of Concrete Deteriorated by Sulfate Attack in Wet-Dry Cycle Environment

Monitoring and Modeling the Damage Evolution in Engineered Cementitious Composites Subjected to Sulfate Attack Through Continuous Ultrasonic Measurements

Creep Characterization of Concrete Suffering Initial Damage

Experimental study of the nonlinear effects generated in a concrete structure with damaged integrity

Axial stress measurement of concrete with nonlinear ultrasonic harmonic method

Use of Non-Linear Ultrasonic Techniques to Detect Cracks Due to Steel Corrosion in Reinforced Concrete Structures

Concrete Microcracks Detection under Compressive Load Based on Nonlinear Ultrasonics Modulation with Broadband Excitation

Study of the Healing Effect of Concrete with Supplementary Cementitious Materials after Early-Age Damage by Acoustic Emission Technique

Fatigue Crack Damage Detection Using Subharmonic Component with Nonlinear Boundary Condition

Ultrasonic signal modality: A novel approach for concrete damage evaluation

MICROCRACKS DETECTION OF THERMAL DAMAGED CONCRETE WITH NONLINEAR ULTRASONIC MODULATION BASED ON BROAD BAND FREQUENCY COUPLING

Study on the Deterioration of Concrete under Dry-Wet Cycle and Sulfate Attack

Mechanical Properties and Damage Evolution of Concrete Materials Considering Sulfate Attack

Microcrack Detection in Thermally Damaged Concrete Based on Broadband Frequency Coupling of Nonlinear Ultrasonic Modulation

Damage Constitutive Model and Mechanical Performance Deterioration of Concrete under Sulfate Environment