Abstract:With the continuous development of manned space technology, higher requirements have been proposed for solid rocket motors. The ignition process of solid rocket motors affects the reliability, stability and safety of their operation. The ignition powder, cover opening pressure and grain length‐diameter ratio are the main factors affecting the ignition process. Therefore, the influence of different factors on the ignition process of solid rocket motors is studied with numerical simulations. Based on the finite volume method, the ignition process of a solid rocket motor is modelled and experimentally verified. Then, the pressure and temperature distribution characteristics during the ignition delay, flame propagation and gas filling times are analysed. Finally, the effects of different ignition powders, cover opening pressures and length‐diameter ratios on the ignition process are compared and analysed. The results show that the model has high prediction accuracy. When the ignition powder is 6 g, the maximum combustion temperature of solid rocket motor increases from 2590 K to 2620 K between 0.1 ms and 0.44 ms. Between 0.44 ms and 3.18 ms, intermittent flame propagation and pressure oscillations occur. In the gas filling time, the flow field gradually stabilizes. Increasing the ignition powder mass is beneficial to the ignition process, but the disadvantages of pressure oscillations should be considered. Increasing the cover opening pressure enhances the ignition process, while increasing the length‐diameter ratio increases the ignition pressure building time. The study results provide technical support for the structural design of solid rocket motors.

Effects of Gas-Phase Speed on Insulator Ablation of Solid Rocket Motor Chamber

Numerical analysis of ablative behavior of silicone resin coated carbon fabric

Influences of Structural Parameters on the Thermal Properties of Coated Glass Fiber Fabrics under Ablation Condition Investigated by Numerical Model

Experimental Research on Electron Density in Solid-Rocket Motor Plume

Investigation on Abnormal Insulator Erosion under High Flight Acceleration Load

Experimental Study on Charring Layer Surface Phases of EPDM Insulator in Elevated Temperature

Ablation Behaviour of C/C–ZrC Composites in a Solid Rocket Motor Environment

Ablation Characteristics Research in Solid Rocket Motor's Combustion Chamber Produced by 3D Printing

Influence Factors on the Multi-Field Coupling Performances of Charring Ablators on the Basis of a Mesoscopic Ablation Model

Experimental and numerical study on slag deposition in solid rocket motor

A Study on the Ablation Performance and Mechanisms of G10 Insulators in a Supersonic Plasma Flame

Evaluation of Numerical Ablation Model for Charring Composites

Numerical prediction of the two-phase flow and radiation effects on the thermal environment and ablation of solid rocket nozzle

Effects of Pyrolysis Reaction and Gas Characteristics on the Thermal Response of Resin-Based Ablative Materials

Numerical simulation of the effect of multiple factors on the ignition process of a solid rocket motor

Simulation and Application of a New Multiphase Flow Ablation Test System for Thermal Protection Materials Based on Liquid Rocket Engine

Investigation of Carbon–Carbon Nozzle Throat Erosion in a Solid Rocket Motor Under Acceleration Conditions

Experimental And Numerical Evaluation Of The Ablation Process Of Carbon/Carbon Composites Using High Velocity Oxygen Fuel System

Nonequilibrium Ablation of Phenolic Impregnated Carbon Ablator

The Detecting Method Investigation on Phase of EPDM Carbon Layer Surface in Solid Rocket Motor

Study on the Ablation Behavior of C/SiC Composite Materials under the Action of Local Structural Thermal Sources