Abstract:Aluminum is an important additive in solid propellants used to improve energy efficiency, but agglomeration of aluminum particles can reduce the specific impulse of the engine, increase two-phase flow losses and cause ablation of the adiabatic layer. Therefore, it is important to understand the mechanism of formation, mode of movement and particle size characteristics of aluminum agglomerates in solid propellants to study the inhibition of agglomeration. In this paper, a three-dimensional numerical simulation of aluminum particle agglomeration near the burning surface of solid propellants was conducted using the discrete unit method based on direct tracking calculations of the detailed motion of individual particles. The model considered physical processes such as burning surface motion, aluminum particle precipitation, turbulent pulsation and the heating and melting of aluminum particle and used a grid-based contact detection method to accelerate the computational process. The agglomeration process of a solid propellant with specific formulation was experimentally investigated. Aluminum particle aggregates underwent splitting, and the final aluminum particle agglomerates were spherical droplets with typical structure. The agglomeration process of this propellant was investigated by means of a simulation. The accuracy of the agglomeration model was verified by comparing the results of the model for the agglomeration process and the shape and size distribution of agglomerates with available experimental data. Compared with the experimental results, the deviations of the equivalent particle sizes of agglomerates D-10, D-50, D-90, D-4,D-3, and D-3,D-2 obtained by using the simulation results were 6.3%, 6.3%, 9.4%, 7.5% and 6.7%, respectively. The aluminum particle agglomeration model established in this paper can predict the particle size distribution of aluminum agglomerates near the burning surface of solid propellants. The model was also used to further investigate the effects of aluminum particle content, ammonium perchlorate (AP) particle size and environ-mental pressure on aluminum particle agglomeration. Increasing the aluminum content or AP particle size aggravated aluminum particle agglomeration, whereas increasing pressure weakened it.

Investigation on Abnormal Insulator Erosion under High Flight Acceleration Load

Reaction Flow Field Change in SRM under High Flight Acceleration Load

A Study on the Ablation Performance and Mechanisms of G10 Insulators in a Supersonic Plasma Flame

Experimental and numerical investigation on thermochemical erosion and mechanical erosion of carbon-based nozzles in hybrid rocket motors

Study on the Transformation of Combustion Mechanism and Ejection Phenomenon of Aluminum Particles in Methane Flame

Investigation into the erosion damage mechanism of High-Temperature, High-Pressure, and High-Speed gasflow on metal surfaces

Effects of Gas-Phase Speed on Insulator Ablation of Solid Rocket Motor Chamber

Exploring the Combustion Mechanism of Single Micron-Sized Aluminum Particles with a Numerical Model

Investigation on Burning Behaviors of Aluminum Agglomerates in Solid Rocket Motor with Detailed Combustion Model

Aluminum Particle Ignition Studies with Focus on Effect of Oxide Barrier

Study on the Ablation Behavior of C/SiC Composite Materials under the Action of Local Structural Thermal Sources

Aluminum Erosion Due to Fault Arcing and Its Effects on Temperature and Pressure in a Closed Air Vessel

Numerical Investigation of In-Flight Behavior of Fe-Based Amorphous Alloy Particles in AC-HVAF Thermal Spray Process

Research on Solving the Structural Instability of Composite Propellants by Using Non-Ablative Cladding Layers

Experimental study on the collision behaviors of micron-sized aluminum droplets with solid wall in high temperature burned gas

Experimental Study on Charring Layer Surface Phases of EPDM Insulator in Elevated Temperature

Simulation and Application of a New Multiphase Flow Ablation Test System for Thermal Protection Materials Based on Liquid Rocket Engine

Investigation of Carbon–Carbon Nozzle Throat Erosion in a Solid Rocket Motor Under Acceleration Conditions

A Heat Transfer Model for Aluminum Droplet/wall Impact

Numerical Simulation of Aluminum Particle Agglomeration Near the Burning Surface of Solid Propellants

Experimental and numerical study on slag deposition in solid rocket motor