Abstract:The thermal protection layer of the solid rocket motor (SRM) is an important elastic material applied to the adhesive shell and propellant; the thickness of the layer is related to the performance of the SRM. This paper proposes a method of linear laser scanning to realise the precise thickness measurement of the thermal protection layer. The custom-designed data acquisition device separately collects distance values from the inner surface of the thermal protection layer, before and after coating, using a linear laser sensor. The two measured distance values are subtracted and D-H modelling (a classical kinematics modelling method proposed by Denavit and Hartenberg) is conducted, then the system errors are analysed and calibrated to obtain the 3D point cloud data of the profile. The iterative closest point (ICP) algorithm is used to register the point cloud data relating to the internal surface, then an octree-based simplification method is proposed to realise the denoising and simplification of the point cloud data. Next, the normal vector of the point cloud data is calculated and the reference surface is extracted as the projection plane. The simplified point cloud is then projected onto the plane and the geometric information of the point cloud data after projection is extracted. A series of distance differences, namely the thickness of the thermal protection layer, is obtained. Finally, the Poisson surface reconstruction algorithm is used to display the inner surface of the thermal protection layer. The results show that the difference between the calculated values and the measured values is less than 0.1 mm, indicating that the thickness of the thermal protection layer of the SRM can be measured by the proposed non-contact method.

The Detecting Method Investigation on Phase of EPDM Carbon Layer Surface in Solid Rocket Motor

Research on the Safety of Long Term Storage Solid Rocket Motor with Debonded Layer

Debonding detection of solid rocket motor based on EMI technology

Experimental Study on Charring Layer Surface Phases of EPDM Insulator in Elevated Temperature

Experimental Research on Electron Density in Solid-Rocket Motor Plume

Thickness measurement method for the thermal protection layer of a solid rocket motor based on a laser point cloud

Simulation and Application of a New Multiphase Flow Ablation Test System for Thermal Protection Materials Based on Liquid Rocket Engine

Study on flame retardancy of EPDM reinforced by ammonium polyphosphate

Optical nondestructive evaluation for minor debonding defects and interfacial adhesive strength of solid propellant

Evaluation of Poly(diaryloxyphosphazene) Elastomer for Heat Shielding Insulations and Morphology of Charred Layers

Effects of Gas-Phase Speed on Insulator Ablation of Solid Rocket Motor Chamber

Structural Diagnosis of Solid Rocket Motors Using Neural Networks and Embedded Optical Strain Sensors

Preparation Optimization of CFRP and EPDM Composite by the Co-Curing Method

Investigation on metal diaphragm of pulse separation device in dual-pulse solid rocket motor

Ablation Characteristics Research in Solid Rocket Motor's Combustion Chamber Produced by 3D Printing

Study on Size Distribution and Flow Characteristics of Condensed Products in Solid Rocket Motor

Detection of Debonding Defects in Carbon Fiber-Reinforced Polymer (CFRP)–Rubber Bonded Structures Based on Active Lamb Wave Energy Analysis

Rate-Dependent Tensile Properties of Aluminum-Hydroxide-Enhanced Ethylene Propylene Diene Monomer Coatings for Solid Rocket Motors

Investigation on Abnormal Insulator Erosion under High Flight Acceleration Load

Experimental study of particles trajectory in firing solid rocket motor with RTR technique part: (I) analysis of feasibility and experimental results

Investigation of thermomechanical properties of solid rocket propellant used in multi-barrel rocket systems