Abstract:In order to provide a basis for the thermal control of the focusing telescope and the optimal design of the support structure, the three-dimensional full-size modeling and finite element analysis of the follow-up X-ray telescope's mirrors group in the Einstein probe project are carried out. The influence of axial and radial temperature gradients, as well as the supported and unsupported structures on the deformation of the mirrors group is studied. The relationship between the surface error and the temperature difference is explored. The results show that the relation between the surface error and the mirrors' radius for unsupported structures under the axial temperature gradient is close to the linear relation, while the relation under the radial temperature gradient is close to the piecewise quadratic relation. When the support structure is thermally deformed, the surface error corresponding to that occurs in the mirrors group. That transforms the in-phase roundness error into the out-of-phase roundness error, and increases the Peak-to-Valley value of the overall surface error of the mirrors group by 32.25 similar to 123.01 %, and the Root-Mean-Square value by 4.13% similar to 5.14 %. For supported structures, the thermally induced surface error is proportional to the temperature difference. When the temperature difference increases by VC , the Peak-to-Valley value and Root-Mean-Square value of surface error increase by 7.76 mu m and 1.12 mu m respectively under the axial temperature gradient, while 9.67 mu m and 1.60 um, respectively, under radial temperature gradient. The thermal-induced surface error of the focusing mirrors has a linear relationship with the mirrors size and temperature difference under certain conditions, and is significantly affected by the deformation of the support structure.

Research on Active Heat Dissipation Experimental System for Focal Plate

Research and Implementation of the Integrated Cooling System for Focal Plate

Experimental Research on Heat Conduction and Temperature Control Method in the Chamber of Large-Scale Geotechnical Centrifuge

Study and Design of A Heat Dissipation System in A Junction Box for Chinese Experimental Ocean Observatory Network

Engineering Design of an Active–Passive Combined Thermal Control Technology for an Aerial Optoelectronic Platform

Method and Verification of Liquid Cooling Heat Dissipation Based on Internal Heat Source of Airborne Long-Focus Aerial Camera

Thermal Analysis of Large Telescope Structure

Adaptive thermal refocusing system for a high-resolution space camera

Experimental Investigation on Two-Stage Thermoelectric Cooling System Adopted in Isoelectric Focusing

Optimized Design of CCD Temperature Control Structure of the Primary Focus Telescope

A new stepped-channel liquid cooling plate thermal management system combined with composite phase change materials

Analysis of Thermal Influence on Optical Fiber Positioning Device of LAMOST

Numerical Study on Thermal Deformation of Wolter-I Focusing Telescope

Numerical and Experimental Study on the Heat Dissipation Performance of a Novel System

Experimental and numerical study of the effect of conjugate heat transfer on film cooling

Optimization Design of LAMOST Focal Plate and Its Support Structure

A Comparative Study of the Thermal Performance of Primary Mirror at the Four Typical Sites

Thermal Analysis and Design of the Aerial Camera’s Primary Optical System Components

Experimental study on temperature uniformity and heat transfer performance of nitrogen loop heat pipe with large area and multi-heat source

Investigation on Temperature Field and Thermal Stress of Dish Solar Concentrator’s Focal Region

Mechanical Design And Analysis Of Focal Plate For Gravity Deformation