Abstract:Heat pipe cooled reactors are solid-state, high temperature reactors with significant thermal expansion which influences the neutronics and thermal analyses. The heat pipe operating conditions determine the heat transfer rates and temperature distribution which then affect the core neutronic and thermal-mechanical behavior, especially during heat pipe failure accidents where the radial heat flux is uneven. A two-phase two-dimensional heat pipe model was developed and coupled to a previous neutronic and thermal-mechanical (N/T-M) model. The coupled neutronic, thermal-mechanical and heat pipe heat transfer (N/T-M/HP) strategy is described here with a focus on the iteration schemes, physical mapping and geometry reconstruction. The coupled N/T-M/HP method was then applied to the KRUSTY heat pipe cooled reactor, an experimental solid-state reactor designed to power space missions. The power distribution and reactivity predicted by the coupled method are validated against previous simulations for the KRUSTY design. The heat pipe model predictions are compared with heat pipe experiments which show that the predicted heat pipe wall temperature is within 30 K of the measured temperatures. A steady-state normal operating case and a single heat pipe failure accident were then simulated to show the redundancy and reliability of the solid-state reactor. For the normal case, the thermal-mechanical feedback is similar to 850 pcm from the cold state to the hot state. The heat transfer rate into each heat pipe is very stable during the iterations. For the single heat pipe failure accident, the heat pipes adjacent to the failure area are the most affected, with those heat loads increasing from 500 W to 640 W and an operating temperature rising by 16 K. In addition, the single heat pipe failure accident significantly increases the stress concentration in the fuel contacted with the failed heat pipe wall, with the peak stress increasing from 53 MPa to 80 MPa, which is very close to the yield stress. Therefore, the mechanical performance of the solid-state reactor should be carefully analyzed during design and operation.

Study on the Improvement of TOPAZ-II system by Using a Heat Pipe Radiator

Performance analysis and optimization of heat pipe-based radiator for space nuclear power system

A review of technologies of temperature-adjustable heat sink

Corrosion Failures of High Temperature Heat Pipes

Performance analysis of indirect contact heat pipe radiator for space nuclear power system

Design, fabrication, and comparative analysis of prototype high-temperature heat pipes charged with sodium for heat pipe cooled reactor NUSTER-100

An Improved Model of the Heat Pipe Based on the Network Method Applied on a Heat Pipe Cooled Reactor

The Super Thermal Conductivity Model for High-Temperature Heat Pipe Applied to Heat Pipe Cooled Reactor

Thermal–hydraulic analysis of space nuclear reactor TOPAZ-II with modified RELAP5

Experimental Study of Composite Heat Pipe Radiator in Thermal Management of Electronic Components

Experimental evaluation on heat transfer limits of sodium heat pipe with screen mesh for nuclear reactor system

Experimental study on thermal and flow characteristics of metal foam heat pipe radiator

Numerical investigation on thermal behavior of high temperature heat pipe based on thermal resistance network model

Investigation of Improved VOF Method in CFD Simulation of Sodium Heat Pipes Using a Multi-Zone Modeling Method

Experimental Study on 100 Hour-Term Performance of High-Temperature Sodium Heat Pipes

Heat Pipe Temperature Oscillation Effects on Solid-State Reactor Operation

Development and application of a transient analysis code for heat pipe cooled reactor systems

Coupled neutronic, thermal-mechanical and heat pipe analysis of a heat pipe cooled reactor

CFD simulation based on film model of high temperature potassium heat pipe at different positions: Horizontal, vertical, and 45° inclined

Research on the Effect of Heat Pipe Temperature Oscillation on Heat Pipe Cooled Reactor Operation

A review of liquid metal high temperature heat pipes: Theoretical model, design, and application