Abstract:Drift chambers are essential in high-energy collider experiments for tracking the trajectory of charged particles. With the increase in peak luminosity, the detector's counting rate also rises, leading to challenges such as high beam backgrounds and an increased probability of signal pile-up in a single drift chamber channel. The Super Tau-Charm Facility (STCF) is a new electron-positron collider proposed by the Chinese particle physics community and the Main Drift Chamber (MDC) is the primary component of the STCF tracking system. The average hit rate of the innermost layer is 440 kHz with the cell size of 1 cm. This high count rate increases the pile-up probability of waveforms, making it difficult to achieve waveform discrimination even with optimized readout electronics performance. Modifying the cell size from approximately 1 cm to 5 mm is expected to decrease the innermost layer hit rate to approximately 210 kHz per channel. This paper presents a novel algorithm for waveform distinction using digital waveform data and integration curves. The algorithm is implemented on an evaluation board based on the Xilinx FPGA to achieve real-time waveform distinction. The algorithm's performance is validated through testing with the evaluation board. The test results indicate that the probability of distinction closely matches the theoretical value, the efficiency of the algorithm is about 96%, and the error probability is less than 4%. This result can serve as a reference for optimizing the MDC structure.

Development of a fan-in and delay module for MWDC based on Flash-ADC acquisition scheme

Development of a multi-channel readout electronics verification system for MWDC detectors

Development of a MWDC Prototype of the CSR External-Target Experiment

Prototype Studies on the Forward MWDC Tracking Array of the External Target Experiment at HIRFL-CSR

A Flash-ADC data acquisition system developed for a drift chamber array and a digital filter algorithm for signal processing*

Simulation and Prototype Testing of Multi-Wire Drift Chamber Arrays for the CEE

Beam test results of the prototype of the multi wire drift chamber for the CSR external-target experiment

Design of the waveform distinction algorithm for the main drift chamber at the Super Tau-Charm facility

Design of a triggerless readout electronics system for CDEX-50

R & D of prototype iTOF-MRPC at CEE

Conceptual design and progress of transmitting $\sim$ MV DC HV into 4 K LHe detectors

A multichannel front end ASIC for PMT readout in LHAASO WCDA

Development of multichannel readout electronics system for MWPC of heavy ion radiotherapy

A Low-Power Time-to-Digital Converter for the CMS Endcap Timing Layer (ETL) Upgrade

Design and performance testing of a T0 detector for the CSR External-target Experiment

Design of a high-dynamic-range prototype readout system for VLAST calorimeter

The external time-of-flight wall for CEE experiment

Design of a Time-to-Digital Converter ASIC and a mini-DAQ system for the Phase-2 upgrade of the ATLAS Monitored Drift Tube detector

A Front-End Electronics Module for Multi-gap Resistive Plate Chambers

Design and test for the CEPC muon subdetector based on extruded scintillator and SiPM

Cosmic Ray Test of Shashlik Electromagnetic Calorimeter Modules for NICA-MPD