Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Development of a multi-channel readout electronics verification system for MWDC detectors

Development of a MWDC Prototype of the CSR External-Target Experiment

Development of a fan-in and delay module for MWDC based on Flash-ADC acquisition scheme

Beam test results of the prototype of the multi wire drift chamber for the CSR external-target experiment

Development of multichannel readout electronics system for MWPC of heavy ion radiotherapy

Simulation and Prototype Testing of Multi-Wire Drift Chamber Arrays for the CEE

Prototype Studies on the Forward MWDC Tracking Array of the External Target Experiment at HIRFL-CSR

Design of a high-dynamic-range prototype readout system for VLAST calorimeter

A multichannel front end ASIC for PMT readout in LHAASO WCDA

Data Acquisition System for CEPC Vertex Detector Prototype

Design of the waveform distinction algorithm for the main drift chamber at the Super Tau-Charm facility

Design and test for the CEPC muon subdetector based on extruded scintillator and SiPM

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Development of High-Rate Mrpcs for High Resolution Time-Of-Flight Systems

Development Of A Multi-Energy Photon-Counting Readout Asic For Czt Detectors

Design of a triggerless readout electronics system for CDEX-50

Electronics design for a muon imaging system using triangular plastic scintillators with WLS fiber readouts

Full-Scale Readout Electronics for the ECHo-100k Experiment

A Scalable Digital Pulse Process Module for the MRPC Detector of Muon Tomography

Development and test of a real-size MRPC for CBM-TOF