Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Conceptual design and progress of transmitting $\sim$ MV DC HV into 4 K LHe detectors

A Novel ZVS High Voltage Power Supply for Micro-Channel Plate Photomultiplier Tubes

Design of a high-dynamic-range prototype readout system for VLAST calorimeter

Feasibility Study of TPC Tracker Detector for the Circular Collider

Mechanical design of an ultra-light vertex detector prototype for CEPC

A Concept for A Dark Matter Detector Using Liquid Helium-4

Design of Prototype Front-end Digital Module for Direct Dark Matter Detection based on LAr

Feasibility Study of TPC Detector at High Luminosity Z Pole on the Circular Collider

ZEPLIN IV: A Future Large-Scale Liquid Xenon Dark Matter Detector

Performance of TPC Detector Prototype Integrated with UV Laser Tracks for the Circular Collider

Status and prospects of TPC module and prototype at high luminosity <i>Z</i> physics on CEPC

Conceptual Design of CEPC Detector Magnet

Design and construction of muon tomography facility based on MRPC detector for high-Z materials detection

ALETHEIA: Hunting for Low-mass Dark Matter with Liquid Helium TPCs

Construction and operation of a Double Phase LAr Large Electron Multiplier Time Projection Chamber

Erratum: Development of Time Projection Chamber prototype integrated with UV laser tracks for the future circular e<sup>+</sup>e<sup>-</sup> collider

Design and commissioning of a 600 L Time Projection Chamber with Microbulk Micromegas

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Design and Performances of Prototype Muon Detectors of Lhaaso-Km2a

Development of the Full-Chain Cryogenic Readout Electronics for the Point-Contact HPGe Detectors

Performance of the continuous ions suppression TPC prorotype for circular collider