Effects of shrinkage fitting on the welding residual stresses of a large electromotor rotor

Wu,AP,Ren,WJ,Zhao,HY,Zou,GS,Ren,JL

2002-01-01

Abstract:A large scale electromotor rotor is usually manufactured by joining the wheel axle, web plate and wheel band with fusion arc welding to reduce its fabrication cycle and Cost. However, the Welding residual stresses combined with the stress concentration effect often lead to brittle fracture around the fusion line. The control of the Welding residual stresses, especially the stresses around the fusion line, is a key to assure the service properties of the rotor. The distributions and characteristics of the residual stresses resulting front the welding of wheel band and web plate and the effects of shrinkage fitting were analysed with a 2D axisymmetric FE model in this paper. The results demonstrated that the welding of wheel band and web plate inade the welds and their surrounding areas subjected to tri-axial tensile residual stresses and become crack susceptible areas. The effects of shrinkage fitting with the welding residual stresses were dependent on the processes of shrinkage fitting and welding. Although shrinkage fitting with cooling first and then welding could reduce welding tensile residual stresses, its effect was not remarkable. While shrinkage fitting followed immediately by welding could effectively decrease the tensile residual stresses. It could change the residual stresses of weld toes and roots front tri-axial tensile state to compressive state.