Abstract:Understanding the void defect formation mechanism and simultaneous predicting the tool service life in friction stir welding are critical for optimizing the welding parameters. However, the void defect formation mechanism in friction stir welding is not yet elucidated. In this study, a novel integrated thermal-fluid-structure coupling model of the friction stir welding process was proposed for simultaneous prediction of the weld formation and tool service life. A new non-uniform distribution model of the tool-workpiece contact pressure was proposed to describe the interaction between the tool and the workpiece. The void defect formation mechanism was quantitatively studied using the proposed integrated thermal-fluid-structure coupling model. The results show that the plastic material flows in the horizontal direction and can completely fill the cavity behind the tool for the welding condition of forming a sound weld. While the tool-workpiece contact interfacial frictional shear stress in the rear of the tool is decreased significantly which leads to a severe decrease in the plastic material flow velocity. Therefore, after bypassing the tool from the retreating side, the plastic material at the bottom of the weld stagnates, and void defect forms in the middle and lower part of the weld at the advancing side. The difference between the maximum and the minimum tool-workpiece contact pressure could serve as a numerical criterion to predict void defects. A sound joint is formed when the difference is lower than the critical value of 15 MPa, while a void defect is formed in the weld if it is higher than this critical value. The maximum equivalent stress acting on the tool is located at the pin root with severe stress concentration at a high welding speed. The front of the tool is subjected to tensile stress while its rear is subjected to compressive stress, therefore the tool is apt to fracture at its root under an inappropriate welding condition. The average normal stress of the tool varies periodically with its period consistent with the rotation period of the tool. The service life of the tool is decreased with the increase in welding speed and the decrease in rotation speed. The model is validated by experimental results.

A new weld material model used in welding analysis of narrow gap thick-walled welded rotor

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Numerical Investigation on Stress Distribution and Evolution in 9cr/2.25cr Dissimilar Welded Rotor Undergoing Welding and Heat Treatment

Influence of Material Model on Prediction Accuracy of Welding Residual Stress in an Austenitic Stainless Steel Multi-pass Butt-Welded Joint

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Establishment and Application of Material Models for Numerical Simulation of Welding Process

The Development of a Continuous Constitutive Model for Thin-Shell Components with A Sharp Change in the Property at Welded Joints

Numerical simulation of material flow and defect formation during FSW to predict weld failure location

Numerical Simulation of Material Flow Behavior of Friction Stir Welding Influenced by Rotational Tool Geometry

Thermal-fluid-structure coupling analysis of void defect in friction stir welding

Simulation and analysis of electron beam welding residual stress in thin-walled high-temperature alloy aeroengine structures

Sensitivity Analysis of History Dependent Material Mechanical Models for Numerical Simulation of Welding Process

Efficient finite element approach for modelling of actual welded structures

Analytical Model to Compare and Select Creep Constitutive Equation for Stress Relief Investigation during Heat Treatment in Ferritic Welded Structure

An Analytical Model of Material Deformation During Friction Welding of Alloy 718

Investigation of material flow and thermomechanical behavior during friction stir welding of an AZ31B alloy for threaded and unthreaded pin geometries using computational solid mechanics simulation

Numerical simulation and analysis of welding of drive axle housing and axle tube

A physically consistent 2D residual stress model for approximating 3D effects in welding

High precision modeling of welding and post welding cold rolling continuous process in numerical simulation