Abstract:Temporary plugging technology is an important drilling technique for maintaining wellbore stability and resolving lost circulation problems. The key to its success lies in the use of materials that can form a tight and stable "temporary plugging layer" with certain pressure bearing capacity and a permeability close to zero in the loss channel near the wellbore. Experimental studies have been conducted to develop adhesion formulations for optimal temporary plugging materials, as the matching relationship between particle size and fracture width is critical [(0.5−1)/1]. By measuring the permeability of the temporary plugging layer under varying confining pressure with a soap foam flowmeter, researchers have been able to evaluate the effectiveness, degradation, and dosages of temporary plugging agents. It has been shown that a single-particle material, such as a walnut shell, has a smaller permeability than a hyperfine CaCO 3 coated temporary plug layer. The latter, however, is less capable of bearing pressure. By combining different materials, such as walnut shells and hyperfine CaCO 3 particles, the researchers were able to create a temporary plug layer that had the lowest permeability and did not change much at variable confining pressures. Its pressure-bearing capacity is strong and the temporary plug works well. Experiments have shown that a ratio of 2:1–3:1 of hyperfine CaCO 3 and walnut shell particles work well for plugging a fracture system with particles of size 2–3 times the fracture width. It developed an evaluation method for temporary plugging agents, studied their plugging capability and degradation performance for reservoir conversion, and evaluated degradation performance after successful temporary plugging. The temporary plugging rate of the temporary plugging agent increased from 98.10% to 99.81%, and the maximum temporary plugging pressure is 50.39 MPa, which can be completely reduced at 150°C for 4 h, meeting the technical requirements of "dense temporary plugging, two-way pressure bearing" to some extent.

Study on the Enhancement Mechanism of the Interface Cementing Strength of YLD-1 Oil/water Well Plugging Agent

Microstructure Formation and Degradation Mechanism of Cementitious Plugging Agent Slurries

MICROSTRUCTURE FORMATION AND INVALIDATION MECHANISM OF SEALANT IN THE SIMULATED ENVIRONMENT AT THE BOTTOM OF OIL-WELL

Development and performance test of an expansive particle temporary plugging agent

Development and field application of downhole crosslinking plugging agent

Study on the Solidification of Modified Drilling Fluid

Optimization of degradable temporary plugging material and experimental study on stability of temporary plugging layer

Research and Application of a New Type of Plugging Agent

Study and Applications of the High-Efficiently Plugging Agent for Thermal Production Wells

Failure Analysis and Countermeasures for Cement Sheath Interface Sealing Integrity in Shale Gas Wells

Study on the mechanical properties and microstructure of a rich-watered grouting material

Effect of Composite Interface Enhancer on the Cementation Strength of Shale Formation–Cement Ring Interface

Experimental Study of Oilfield Water Plugging with Organic Chromium Gel

The Research of Polymer Film-Forming Plugging Agent for Drilling Fluid

Development and Performance of Urea–Formaldehyde Resin/Montmorillonite Intercalation Composite Horizontal well Plugging Agent

Development and performance evaluation of hydrophobic association plugging agents for sealing formation prior to cementing

Experimental Study on the Compressive and Shear Mechanical Properties of Cement–Formation Interface Considering Surface Roughness and Drilling Mud Contamination

Exploring on Grouting Reinforcement Mechanism of Expansive Slurry

Experimental study of wellbore strengthening on pressure-bearing capacity

Investigation on coupling deposition and plugging of hydrate and wax in gas–liquid annular flow: Experiments and mechanism

Performance Evaluation and Field Application of Nano Plugging Agent for Shale Water-Based Drilling Fluid