Abstract:The sustained casing pressure (SCP) phenomenon of shale gas and oil wells occurs frequently after fracturing; therefore, in order to assess the cement sheath's integrity in the vertical well portion, the cement stones were subjected to a compression test under different temperatures and confining pressures to obtain the mechanical parameters of the cement sheath at different well depths. The integrity of the cement ring between the production casing and the intermediate casing was then investigated using the Moore–Coulomb criterion. We also took into account other elements including pump pressure, production casing wall thickness, and cement ring mechanical properties. The results show that (1) the compressive strength, Poisson's ratio, and Young's modulus of cement stone vary obviously under different confining pressures and temperature conditions, and the cement stone shows elastic–brittle failure characteristics at 20 °C. The compressive strength, Poisson's ratio, and Young's modulus increase with the confining pressure, but the Young's modulus and compressive strength gradually decrease with the increase in temperature, while the stress–strain curves show obvious plastic failure characteristics at 80 °C and 130 °C. (2) The tangential tensile stress decreases and depth increases from the wellhead to the intermediate casing shoe, while the radial compressive stress of the cement sheath increases. The stress state of the cement sheath changes abruptly at the position of the casing shoe due to the change in casing layers, and under the intermediate casing shoe, the tangential tensile stress changes from tension to compression. When a conventional cementing slurry system is used, the integrity of the cement sheath above the intermediate casing shoe will fail during fracturing. (3) Reducing the pump pressure and increasing casing wall thickness can reduce the tangential and radial stresses of the cement sheath, but the integrity of cement sheath cannot be fully guaranteed. For the cement sheath's sealing integrity, it is advantageous to decrease the Young's modulus and raise its strength.

MICROSTRUCTURE FORMATION AND INVALIDATION MECHANISM OF SEALANT IN THE SIMULATED ENVIRONMENT AT THE BOTTOM OF OIL-WELL

Long-term Thermal Performance of Oil Well Cement Modified by Silica Flour with Different Particle Sizes in HTHP Environment

Microstructure Formation and Degradation Mechanism of Cementitious Plugging Agent Slurries

Microstructure and Sealing Mechanism of High-temperature Sealant

Sealing Failure Mechanism and Control Method for Cement Sheath during Hydraulic Fracturing

Study on the Enhancement Mechanism of the Interface Cementing Strength of YLD-1 Oil/water Well Plugging Agent

Failure Analysis and Countermeasures for Cement Sheath Interface Sealing Integrity in Shale Gas Wells

Systematic Experimental Investigation on In-Situ Self-Adaptive Sealing Property of Composite Pressure-Activated Sealant for Curing Minor Tubular Leaks

HYDRATION AND HARDENING OF CLASS G OILWELL CEMNET

Numerical Simulation Research on Seal Failure of Remedial Cement Sheath in Oil and Gas Wells

Influence of Latex on the Hydration Products and Microstructure of Oil Well Cement Pastes

Hydration and hardening of class G oilwell cement

Development of cementitious capillary crystalline waterproofing agents and durability study of concrete in the presence of chloride with sulfate in aqueous environment

HYDRATION AND HARDENING OF CLASS G OILWELL CEMENT WITH AND WITHOUT SILICA SANDS UNDER HIGH TEMPERATURES

The Failure Mechanism and Countermeasures of Cement Sheath in Vertical Section of Well during Hydraulic Fracturing

Construction and Application of High-Strength Flexible Cement Sheath for Deep and Ultra-deep Shale Gas Cementing

Laboratory Research of New Sealing Under Pressure Cement Slurry System

Study on the Solidification of Modified Drilling Fluid

Effects of porous structure on the deformation failure mechanism of cement sheaths for wellbores

Degradation of chemical and mechanical properties of cements with different formulations in CO2-containing HTHP downhole environment

Occurrence Mechanism of the Abnormal Gelation Phenomenon of High Temperature Cementing Slurry Induced by a Polycarboxylic Retarder