Abstract:To design noise-shaping successive approximation register (NS-SAR) analog-to-digital converters (ADCs) with high resolution and good power efficiency, two key bottlenecks need to be addressed. One is to realize a high-order loop filter with low circuit overhead, and the other is to mitigate the thermal noise. This article presents an NS-SAR ADC that synergistically addresses both challenges. To achieve high-order efficiency, it proposes an innovative error feedback-cascaded integrator feedforward (EF-CIFF) structure that realizes third-order noise shaping using only a single amplifier. It combines the merits of both structures, showing improved robustness, and is free of dc offset concern. On reducing the kT/C noise, this work features a sampling kT/C noise cancellation (SNC) technique that reuses the native hardware of the EF-CIFF structure. An open-loop self-quenching floating-inverter dynamic amplifier (FIDA) is used to support all amplification with low noise and power. Prototyped in 65-nm CMOS, this work achieves 84.8-dB signal-to-noise-distortion ratio (SNDR) with 625-kHz bandwidth (BW) (OSR = 8) and 119 $\mu \text{W}$ , leading to 182-dB Schreier Figure of Merit (FoM). It uses only 0.8-pF input capacitance, which is $5\times $ smaller than prior NS-SAR ADCs with similar oversampling ratio (OSR) and SNDR.

16.5 A 13b 0.005mm2 40ms/s SAR ADC with Kt/c Noise Cancellation

16.5 A 13b 0.005mm<sup>2</sup> 40MS/s SAR ADC with kT/C Noise Cancellation

A SAR ADC with Reduced kT/C Noise by Decoupling Noise PSD and BW

A 13-Bit 0.005-Mm2 40-Ms/s SAR ADC with Kt/c Noise Cancellation

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

An 18-Bit 2MSPS SAR ADC with Double Passive Noise-Shaping Calibration

A 16-Channel 12-Bit Rail-to-rail Successive Approxmation Register ADC for AFEs

A 0.004-Mm2 200-Ms/s Pipelined SAR ADC with Kt/c Noise Cancellation and Robust Ring-Amp

A 93.6Db-Sndr 5Khz-Bw Fully Dynamic Hybrid CT-DT Noise Shaping SAR ADC

A 0.004mm2 200MS/S Pipelined SAR ADC with Kt/c Noise Cancellation and Robust Ring-Amp

A 13.8-ENOB Fully Dynamic Third-Order Noise-Shaping SAR ADC in a Single-Amplifier EF-CIFF Structure with Hardware-Reusing Kt/c Noise Cancellation

3.4 A 0.01mm2 25µw 2ms/s 74Db-Sndr Continuous-Time Pipelined-SAR ADC with 120ff Input Capacitor

A 10-Bit 100-Ms/s SAR ADC with Always-on Reference Ripple Cancellation.

An 18-Bit SAR ADC with Mixed DAC and Capacitive Recombination Calibration

A 93.6-Db SNDR Fully Dynamic CT–DT Noise-Shaping SAR ADC with Closed-Loop Capacitively Coupled Two-Stage FIA

A Fully-Dynamic Kt/c-Noise-canceled SAR ADC with Trimming-Free Dynamic Amplifier.

A 13.5-ENOB, 107-μW Noise-Shaping SAR ADC With PVT-Robust Closed-Loop Dynamic Amplifier

A 16.5-μW 73.7-dB-SNDR Second-Order Fully Passive Noise-Shaping SAR ADC With a Hybrid Switching Procedure

A 78 dB 0.417 mW Second-Order NS SAR ADC with Dynamic Amplifier-Assisted Integrator

A 1.5MSPS, 120 dB SFDR, ±10 V input range SAR ADC with sampling nonlinearity compensation and inherent 2-b coarse ADC for MSBs decision

A 12.9-ENOB 50.6 Fj/conv.step Time-Amplitude Aligned Level-Crossing SAR ADC