Abstract:This work presents a 14-bit 500 MS/s single-channel pipelined-successive-approximation-register (SAR) analog-to-digital converter (ADC) with an adaptively biased floating inverter amplifier (AB-FIA) as the residue amplifier (RA) and a hybrid reference ripple mitigation (H-RRM) technique to relax the power and area burden on the reference stabilization. Leveraging the adaptively biased architecture in the last stage FIA, the speed and open-loop gain of the proposed two-stage FIA are enhanced compared with the conventional cascode counterpart. Besides, the impact of the reference error on the pipelined-SAR conversion accuracy is alleviated by hybridizing the improved reference ripple cancellation (RRC), reference ripple neutralization (RRN), and reference buffer (RBUF). The improved RRC removes the potential noise coupled from the floating capacitor to counter the decision error during the sub-SAR conversion in the first stage. Meanwhile, the RRN facilitates a rapid reference recovery. These acts constitute the H-RRM, which assists a high-speed and high-resolution pipelined-SAR process with a relaxed integrated reference RBUF with low-power and compact area. The prototype ADC was fabricated in a 28 nm CMOS process; it consumes 6.34 mW total power at 500 MS/s, including 2.4 mW dynamic power of RBUF. It occupies an active area of 0.018 mm $^{2}$ , which the ADC core area of 0.0168 mm $^{2}$ and the area of RBUF with a 2.3 pF decoupling capacitor is 0.00105 mm $^{2}$ . The measured signal to noise and distortion ratio (SNDR) and spurious free dynamic range (SFDR) are 64.2 dB and 80.55 dB with a Nyquist input, respectively, leading to a 170.2 dB Schreier figure-of-merit (FoM) (FoM $_{\mathrm{S}}$ ) and 9.6 fJ/conversion-step Walden FoM (FoM $_{\mathrm{W}}$ ).

A 10-Bit 100-Ms/s SAR ADC with Always-on Reference Ripple Cancellation.

A 15-Bit, 5 MSPS SAR ADC with On-Chip Digital Calibration

A 10-Bit 250-KS/s 1.24-uW SAR ADC for IoT Sensors with Energy-Efficient Comparator.

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A 10-Bit 120-Ms/s SAR ADC with Reference Ripple Cancellation Technique.

A 10 MS/s 10 bit SAR A/D Converter in RF System

A 14b 500 MS/s Single-Channel Pipelined-SAR ADC With Reference Ripple Mitigation Techniques and Adaptively Biased Floating Inverter Amplifier

A 13-Bit 0.005-Mm2 40-Ms/s SAR ADC with Kt/c Noise Cancellation

A 10-bit 200MS/s SAR ADC with reference buffer in 40nm CMOS

An 8-MS/s 16-bit SAR ADC With Symmetric Complementary Switching and Split Passive Reference Segmentation in 180-nm Process

A Single-Ended 10-Bit 200 Ks/s 607 Μw SAR ADC with an Auto-Zeroing Offset Cancellation Technique

A 700-Ms/s 6-Bit SAR ADC with Partially Active Reference Voltage Buffer

An 11-Bit 200 MS/s Subrange SAR ADC with Low-Cost Integrated Reference Buffer

A 0.004-Mm2 200-Ms/s Pipelined SAR ADC with Kt/c Noise Cancellation and Robust Ring-Amp

A Low Power 10-Bit 100-Ms/s SAR ADC in 65nm CMOS

An 11-Bit 500 MS/s Two-Step SAR ADC with Non-Attenuated Passive Residue Transfer.

A 12-Bit 20ms/s Asynchronous SAR ADC

A 10-B 750µw 200ms/s Fully Dynamic Single-Channel SAR ADC in 40nm CMOS

A 10-b 750 mu W 200MS/s Fully Dynamic Single-Channel SAR ADC in 40nm CMOS

A 10b 250ms/s SAR ADC with Speed-Enhanced SAR Logic and Free Time More Than a Half of Sampling Period

A 24-µW 11-bit 1-MS/s SAR ADC with a bidirectional single-side switching technique