Abstract:In this study, the effects of Si content on the glass-forming ability (GFA), thermal stability, annealing window, nanocrystallization process, and soft magnetic properties (SMPs) of Fe 86.3-x Si x B 10 P 2 Cu 1.7 (x = 0, 1, 2, 3, and 4, denoted as Si0, Si1, Si2, Si3, and Si4, respectively) alloys with high Fe and Cu contents were investigated. Moderate addition of Si (x = 1, 2, and 3) enhanced the GFA and suppressed the precipitation of compound phases, thus leading to a large crystallization temperature interval ( ΔT x ) exceeding 185 °C for the alloys. Appropriate addition of Si also resulted in the formation of high-density and fine pre-existing α-Fe nanocrystals in as-spun ribbons and a high growth active energy of α-Fe crystals during the subsequent nanocrystallization process for the Si1, Si2, and Si3 alloys, enhancing competitive growth between α-Fe crystals and resulting in fine nanostructure and excellent SMPs of the nanocrystalline alloys (NAs). As a result, the Si1, Si2, and Si3 NAs obtained by annealing at 420 °C for 30 min exhibited excellent SMPs with saturation magnetic flux density ( B s ) up to 1.84 T and a low coercivity ( H c ) of approximately 10 A/m. In addition, statistical analysis of the relationship between the average grain size ( D ) of α-Fe crystals and H c values of the NAs indicated that an H c α D 3 dependence is observed when the D is less than approximately 30 nm, while this dependence follows the well-known H c α D 6 relationship when the D is above 30 nm. The dependency relationship between D and H c of NAs can guide the selection of an appropriate annealing process to optimize their SMPs.

Thermal, Structural and Soft Magnetic Properties of FeSiBPCCu Alloys

Effect of Co Addition on the Phase Structure and Magnetic Properties of Fe-Si-Al Alloys

Influence of Annealing Temperature on Microstructure and Magnetic Properties of FeSiNbCuBP Amorphous Alloys

Local Structure, Nucleation Sites and Crystallization Behavior and Their Effects on Magnetic Properties of Fe81Si X B10P8−xCu1 (x = 0~8)

Tunable and attractive magnetic properties of FeBPSiCu alloys

Effects of boron content on the structure and magnetic properties of Fe81-xSi13BxMo2Cr1Cu1P2 nanocrystalline alloys

Structure and soft magnetic properties of Fe-Si-B-P-Cu nanocrystalline alloys with minor Mn addition

Optimization of Crystallization Behavior and Soft Magnetic Properties of the Si-free Fe-B-P-C-Cu Nanocrystalline Alloys by Cu Content Tuning

The role of Cu content on structure and magnetic properties of Fe–Si–B–P–Cu nanocrystalline alloys

Crystallization behavior, soft magnetic properties and good bending ductility of high Fe content FeSiBCuPC alloys induced by composition design

Effect of P addition on soft magnetic properties of Fe–Si–B–P–Cu–C nano-crystalline alloys

Improving the Amorphous Forming Ability and Magnetic Properties of FeSiBPCu Amorphous and Nanocrystalline Alloys by Utilizing Carbon

The Effects of Si Substitution with C on the Amorphous Forming Ability, Thermal Stability, and Magnetic Properties of an FeSiBPC Amorphous Alloy

Investigation of glass forming ability, crystallization behavior, and soft magnetic properties of Fe–B–P–C–Cu alloy ribbons

Effects of P addition on the glass forming ability, crystallization behaviour and soft magnetic properties of FeNi-based amorphous alloy

Effect of P microalloying on magnetic properties and structure of FeSiBNbCu nanocrystalline alloy

Magnetic properties and structure of short-term annealed FeCuBPSi nanocrystalline alloys

Excellent Soft Magnetic Properties and Enhanced Glass Forming Ability of Fe-Si-B-C-Cu Nanocrystalline Alloys

Evolution from Amorphous to Nanocrystalline and Corresponding Magnetic Properties of Fe-Si-B-Cu-Nb Alloys by Melt Spinning and Spark Plasma Sintering

Effects of Si addition on crystallization process and soft magnetic properties of high-Fe and high-Cu-content Fe-Si-B-P-Cu nanocrystalline alloys

The role of P content on the glass-forming ability and the magnetic properties of FeSiBPC amorphous alloys