Abstract:This paper presents the results of research on the impact of the use of different tools and the shape of the additional rivet, on the geometric quality of the joint, the energy consumption of the forming process, the distortion of the steel samples, and the load capacity of the joints. The tests were carried out for DX51D steel sheets with a thickness of 1.5 [mm] joined by using three different sets of tools. A steel rivet with a hardness of 400HV1 and various shapes was used for the tests. In addition to the full rivet, two types of rivet were used, the first with a through hole and the second with a depth of hole of 3 [mm]. The holes in the rivet had different diameters: 1.0, 1.5, 2.0 and 2.5 [mm]. The influence of changing the shape of the rivet (hole and its diameter) on the change in forming force and energy consumption of the joining process was analyzed. The lowest forming force was achieved for a rivet with a through hole and a hole diameter of 2.5 [mm]. The lowest joint forming force was obtained for the die with movable segments. For joints made with three tool arrangements and a series with a modified rivet, the amount of sheet metal deviation was analyzed. Of the three cases of arrangement of tools used to form the joint, the largest deviation of the sheets occurred at the clinch joint formed with a solid round die. In the case of a series of clinch-rivet joints with a modified rivet, the greatest deviation of the sheets occurred for the rivet with a hole of 1.5 [mm]. Changes in the geometric structure of the joint were also studied, and changes in the surface of the sheets in the joint area were observed. The highest value of the interlock in the joint was obtained when a solid rivet was used in the clinch-riveting technology. The strength of the joints was also identified in the lap shear test and the energy consumption at failure was determined. The use of a rivet increased the maximum load capacity to almost twice that of the clinch joint.

Forming Mechanism of the Repairing Process on Clinched Joint

Investigation of a renovating process for failure clinched joint to join thin-walled structures

Comparative Investigation of Three Different Reforming Processes for Clinched Joint to Increase Joining Strength

Investigation of the Restored Joint for Aluminum Alloy

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Comparative Investigation of Auxiliary Processes for Increasing the Strength of Clinched Joints

Research on a single-point butt clinching process with various forming forces

In-situ Solid State Repairing Method for Failure Flat Clinched Joint of Aluminum Alloy

Investigation to enhance the mechanical properties of damaged flat-clinching joints by reconditioning processes

Optimization of a Reshaping Rivet to Reduce the Protrusion Height and Increase the Strength of Clinched Joints

Recent development of improved clinching process

Experimental Investigation On The Joining Of Aluminum Alloy Sheets Using Improved Clinching Process

Effect of blank holder force on joining quality of the flat clinch-rivet process

Influence of thickness combinations on mechanical properties of joints produced by clinch riveting with rigid rivet

Forming Process and Morphology Control of Mechanical Clinch Joint of Steel/Aluminum Sheet

Research on material flow in flat clinching process and joint failure mechanism

Mechanical Properties of the Two-Steps Clinched Joint with a Clinch-Rivet

Mechanical properties of tubular rivet-reinforced joints realized with different reinforcing loads

A Comparative Study of Local Heat Treatment for Enhancing Overall Mechanical Properties of Clinched Joints

Experimental Research on the Compressed Joints with Different Geometrical Parameters

The Energy Consumption of the Process of Joining Steel Sheets with the Use of Clinching With and Without an Additional Rivet, and Analysis of Sheet Deformation and Mechanical Strength of Joints