Abstract:Goal. During the production of railway axles, the main target is to obtain a uniform metal structure with a grain size not larger than number 5 across the entire section of the produced axle. Moreover, in accordance with the demands of railway axle consumers, the differences in grain size numbers should not exceed 2. However, due to multi-stage processing and repeated heating of axle material, the fulfillment of aforesaid requirements is very difficult and the differences in grain size numbers are usually found as 4. Therefore, it is necessary to develop a special deformation regime for controlling the sizes and the uniformities of metal grains in the finished product. Methods. We employed experimental and theoretical investigations to reveal the microstructure refinement in the deformation zone of the produced railway axle. The experimental investigation was carried out under the production conditions, whereas the theoretical investigation was performed based on the theory of plasticity and finite element method. Results. Furthermore, the regularities of process parameters in the deformation zone were revealed; hence, a new deformation regime was developed, and consequently, the quality of the finished railway axle was improved. Scientific novelty. Rolling of solid railway axle required special de-formation regimes that differed from the deformation regimes for rolling of other types of products. Deformations in vertical and edging directions with edging reduction were less penetrative to the central zone of the billet as compared to surface layers, thus resulting in an increase in energy consumption and equipment load of the rolling mill. Rolling with edging reduction caused a worse de-formation at the central zone of the billet in the box caliber.Rolling without edging reduction caused large deformations in central layers of the billet and led to a significant improvement in the metal structure of the axle.

New technique of precision necking for long tubes with variable wall thickness

Significance Analysis of Weld and Processing Parameters on Wall Thinning and Cross-Sectional Deformation of Welded Tube in Nc Bending Process

Numerical Analyses of Deformation Mechanisms in a Novel Dimensional Calibration Technique for Thin-Walled, Open Extrusions

Axial Hydro-Forging Sequence for Variable-Diameter Tube of 6063 Aluminum Alloy

Influence of processing parameters on the forming quality of high strength steel tube during single pass neck-spinning

Investigation of Thickness Variation in Axial Hydro-Forging Sequence for Variable-Diameter Tubes

The development of a new deformation regime for microstructure refinement in solid railway axles by hot deformation optimization

Local Electrically Assisted Necking and Thickening Technology for 5A02 Aluminum Alloy Tube

Study on Barrelling Behavior of Variable-Diameter Tubes in Axial Hydro-Forging Sequence

Experimental and Numerical Investigation on Axial Hydro-Forging Sequence of 6063 Aluminum Alloy Tube

Defection and Process Study on Thin-Wall Aluminum Tube Neck-Spinning

Bulging simulation study on preforming tube of bulging-pressing compound-deforming process for automobile axle housing

Analysis of Deformation in Viscous Medium Outer Pressure Necking for Thin-Wall Parts with Variable Diameter Section

Research on neck-spinning process of 3D non-axisymmetric tubes

Experimental Study of the Tube Axial Compression Forming Process with Free Dieless Deformation

Investigation on limited thickening ratio of upsetting with a controllable deformation zone

A new tube forging process for manufacturing hollow parts with inner flange at an arbitrary location

Inner and Outer Pressure Forming of Nickel Based Super-Alloy Thin-Walled Part with Variable Diameter Sections

Numerical simulation and experimental research on the multi-pass neck-spinning of non-axisymmetric offset tube

A new method for hydroforming of thin-walled spherical parts using overlapping tubular blanks

Effect of forming parameters on the neck-spinning process of 3D non-axisymmetric tubes