Abstract:Infeed rotary swaging is a cold forming production technique to reduce the diameter of axisymmetric components. The forming is achieved discontinuously by a series of radial strokes that are spread over the shell of the part. Due to tolerances within the rotary swaging machine, these strokes perform individually and the resulting stroke pattern is not homogeneous with regards to circumferential and longitudinal distribution. Nevertheless, in combination with the high number of performed strokes and the large contact area between the dies and the part, the external part properties, such as diameter, roundness and surface roughness, show even values along the finished part. In contrast, strength-defining internal part properties, like microstructure and residual stress components, are more sensitive to the actual pattern and temporal sequence of the individual strokes, which is investigated in this study. The impact of process fluctuations during the conventional process, which are induced by the tolerances of machine tool components, was verified by numerical simulations, physical tests and measurements of residual stress distributions at the surface and at depth. Furthermore, a method is introduced to maintain the stroke following angle ∆φ at zero by flat dies, and thus the actual pattern and temporal sequence of the strokes was homogenized. The results show that the residual stress fluctuations at the surface could be controlled and reduced. Furthermore, it is demonstrated that the depth profile of the residual stresses at a distance of 300 µm from the surface developed independently from the process fluctuations.

Influence of processing parameters on the forming quality of high strength steel tube during single pass neck-spinning

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Plasticity Improvement of Ball-Spun Magnesium Alloy Tube Based on Stress Triaxiality

Influence of process parameters on the flow forming quality of thin-walled tube with large diameter-thickness ratio

Influence of Inner Roller Geometric Parameters on Counter-Roller Spinning with 6061 Aluminum Alloy Tube

Study of Dieless Radial Spinning for Thick-Walled Cylindrical Parts With External Grooves

The Analytical Model of Ball-Spinning Force for Processing an Annular Groove on the Inner Wall of a Steel Tube

Process factors influencing spinning deformation of thin-walled tubular part with longitudinal inner ribs

Mechanism of Increasing Spinnability by Multi-Pass Spinning Forming – Analysis of Damage Evolution Using a Modified GTN Model

Finite Element Analysis of Stress and Strain Field in Thin-wall Taper Workpiece During Spinning Forming

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

Research on Plastic Deformation Behavior of Double Rollers Clamping Sheet Metal Spinning Process

Numerical Simulation of Influences of Process Parameters on the Spinning Moment and Quality of Double-Roller Clamping Spinning

Research on the Influence of Main Spinning Process Parameters on the Forming Quality of 20 Steel by Strong Spinning

Influence of Roller Distribution Modes on Spinning Force During Tube Spinning

Study on the spinning process of thin-walled aluminum alloy vessel head

Influence of Process Fluctuations on Residual Stress Evolution in Rotary Swaging of Steel Tubes

Research on the Mechanism and Processability of Roll Forming

Study of Deformation Mechanism of Backward Ball Spinning of Thin-Walled Tube with Longitudinal Inner Ribs

Experimental Investigation of Current Intensity and Feed Speed in Electrically Assisted Necking and Thickening of 5A02 Aluminum Alloy Tubes

Multi-pass Spinning of Thin-Walled Tubular Part with Longitudinal Inner Ribs