Abstract:Thin-wall rotary parts with complex flange geometry have been widely used in many equipments, especially industrial fans and blowers. Conventional stamping and welding methods for those parts have some limitations such as low manufacturability, poor quality and low utilization ratio of material. Thus in this paper, a new spinning process, double-roller clamping spinning process (DCSP), is introduced to form the complex flange shape. During the process, the cylindrical workpiece made from sheet metal is held by the internal expanding clamp device and rotates together with the device, while two spinning rollers deforms and shapes the material of flange region according to the rollers moving paths. In order to deeply investigate deformation mechanisms of DCSP, both 2D and 3D FE simulation models are built and the spinning process for rectangular cross-section shape of flange is simulated by using explicit FE code ABAQUS/explicit. Simulation results show large flange length can induce wrinkles on the inner region of flange. After spinning process simulation, the springback of workpiece is calculated by implicit FE code ABAQUS/standard. The effect of flange length on the thickness reduction of workpiece is obtained by theoretical analysis.

Defection and Process Study on Thin-Wall Aluminum Tube Neck-Spinning

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Study on the spinning process of thin-walled aluminum alloy vessel head

Spinning Process of 2219 Aluminum Alloy Tubes for Used in Hydroforming

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

Study of Dieless Radial Spinning for Thick-Walled Cylindrical Parts With External Grooves

Study of Deformation Mechanism of Backward Ball Spinning of Thin-Walled Tube with Longitudinal Inner Ribs

3D Rigid–plastic FEM Numerical Simulation on Tube Spinning

Research on Material Flow Rule of Backward Tube Spinning Process

Process factors influencing spinning deformation of thin-walled tubular part with longitudinal inner ribs

Multi-pass Spinning of Thin-Walled Tubular Part with Longitudinal Inner Ribs

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Plasticity Improvement of Ball-Spun Magnesium Alloy Tube Based on Stress Triaxiality

Study on Counter-Roller Spinning Technology of Large Diameter Aluminum Alloy Cylindrical Parts

Research on Plastic Deformation Behavior of Double Rollers Clamping Sheet Metal Spinning Process

Spinning deformation mechanism of aluminum alloy cylinder with multi-level stiffeners based on numerical simulation

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Analysis of Backward Ball Spinning of Thin-Walled Tube Part with Longitudinal Inner Ribs Based on FEM

Analysis of ball spinning formability of thin-walled tubular parts of aluminum alloy

Finite Element Analysis of Stress and Strain Field in Thin-wall Taper Workpiece During Spinning Forming

Evaluation of Formability and Material Characteristics of Aluminum Alloy Friction Stir Welded Tube Produced by a Novel Process