Abstract:A new way on the magnitude and position of direction change of shear deformation resulted from rolling geometry and friction described by two parameters of Rf and Rp changed with practical rolling conditions is established for analyzing rolling textures. It is found that {001} <110> shear texture is dependent on the parameters of Rf and Rp, and rolling neutral angle is at the middle point of rolling deformation zone, i.e. Rp = 0.5, which favors development of {001}<110> shear texture. The results show that the rolling textures simulated by taking into account of Rf and Rp changed with practical rolling conditions are in better agreement with the measured than that of Rp = 0.5 in rolled high purity Al. Introduction Rolling textures and deformation microstructures have been demonstrated to be changed with rolling geometry and friction on contact surfaces between rollers and sample in previous investigations [1, 2, 3], in which {001}<110> shear texture and micro-shear bands with Cube orientation were found in rolled high purity aluminum with heavier rolling friction. However, the presented ways on effect of rolling geometry and friction on rolling texture components were either simple or complex, and rolling neutral angle position was hypothesized to be at the middle point of rolling deformation zone (RDZ) in literatures [4, 5, 6]. In current investigation, shear deformation can conventionally be changed with practical rolling conditions including rolling geometry and friction, especially, the position of direction change of shear deformation, i.e., rolling neutral angle, is not hypothesized to be at the middle point of RDZ per pass. Development of rolling textures in high purity Al rolled up to different total engineering strains is studied by experiment and modeling. Application of practical conditions on rolling texture modeling Practical Rolling conditions. All that rolling conditions are constrained by three angles, α, β and γ, and a relationship of the three angles can be described as known as

Influences of Texture of FCC Metals on Their Mechanical Properties

Theory Calculation of Sliding System of FCC Metals During Rolling Deformation

The role of Goss-oriented texture for brass-type texture in nickel-based metals during cold rolling

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Effects of microstructure and texture on the deep drawability of C10200 copper sheets

Investigation on Grain Size Effect of Rolling Texture in Copper

Crystal Plasticity-Based Assessment of Constitutive Laws for Microstructure and Rolling Texture Capture in Ferritic Stainless Steel During Cold Rolling

Differences in Texture Evolution from Low-Entropy to High-Entropy Face-Centered Cubic Alloys During Tension Test

Effect of Direction Change of Shear Deformation on the Textures in Rolled High Purity Al

Systematic investigation of the texture evolution of Cu-Ni alloys with different strains

Microstructure and Texture Evolution in Thermomechanically Processed FCC Metals and Alloys: a Review

Understanding the Mechanisms of Texture Evolution of a Fe-24Cr-22Ni-7Mo Super Austenitic Stainless Steel During cold Rolling and Annealing

Effect of texture types on microstructure evolution and mechanical properties of AZ31 magnesium alloy undergoing uniaxial tension deformation at room temperature

Orientation factor analysis of deformation mechanisms under special processing techniques in AZ31 magnesium alloys

Micro-mechanical aspects of texture evolution in nickel and nickel–cobalt alloys: role of stacking fault energy

An Investigation on Rolling Texture Transition in Copper Preprocessed by Equal Channel Angular Pressing

Correlation of Grain Size, Stacking Fault Energy, and Texture in Cu-Al Alloys Deformed under Simulated Rolling Conditions

Determination of the macroscopic residual stress: Modeling and experimental evaluation of texture and local grain-interaction

Texture development and mechanical behavior of Zircaloy-4 alloy plates fabricated by cold rolling and annealing

Texture Evolution and Their Effects on the Mechanical Properties of Duplex Mg–Li Alloy

Investigation of the Evolution of Schmid Factors (SF) in 316 Stainless Steel during In Situ Plastic Deformation