Abstract:A new way on the magnitude and position of direction change of shear deformation resulted from rolling geometry and friction described by two parameters of Rf and Rp changed with practical rolling conditions is established for analyzing rolling textures. It is found that {001} <110> shear texture is dependent on the parameters of Rf and Rp, and rolling neutral angle is at the middle point of rolling deformation zone, i.e. Rp = 0.5, which favors development of {001}<110> shear texture. The results show that the rolling textures simulated by taking into account of Rf and Rp changed with practical rolling conditions are in better agreement with the measured than that of Rp = 0.5 in rolled high purity Al. Introduction Rolling textures and deformation microstructures have been demonstrated to be changed with rolling geometry and friction on contact surfaces between rollers and sample in previous investigations [1, 2, 3], in which {001}<110> shear texture and micro-shear bands with Cube orientation were found in rolled high purity aluminum with heavier rolling friction. However, the presented ways on effect of rolling geometry and friction on rolling texture components were either simple or complex, and rolling neutral angle position was hypothesized to be at the middle point of rolling deformation zone (RDZ) in literatures [4, 5, 6]. In current investigation, shear deformation can conventionally be changed with practical rolling conditions including rolling geometry and friction, especially, the position of direction change of shear deformation, i.e., rolling neutral angle, is not hypothesized to be at the middle point of RDZ per pass. Development of rolling textures in high purity Al rolled up to different total engineering strains is studied by experiment and modeling. Application of practical conditions on rolling texture modeling Practical Rolling conditions. All that rolling conditions are constrained by three angles, α, β and γ, and a relationship of the three angles can be described as known as

Theory Calculation of Sliding System of FCC Metals During Rolling Deformation

Influences of Texture of FCC Metals on Their Mechanical Properties

The Influence of Warm Rolling Reduction on Microstructure Evolution, Tensile Deformation Mechanism and Mechanical Properties of an Fe-30Mn-4Si-2Al TRIP/TWIP Steel

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Formation mechanism of dynamic multi-neutral points and cross shear zones in corrugated rolling of Cu/Al laminated composite

Crystal Plasticity-Based Assessment of Constitutive Laws for Microstructure and Rolling Texture Capture in Ferritic Stainless Steel During Cold Rolling

Research on Effects of Rolling-Drawing Deformation on Performance of Cu-10Ni-1Fe-1Mn Alloy

Effect of Direction Change of Shear Deformation on the Textures in Rolled High Purity Al

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Microstructure evolution, mechanical properties and tailoring of coefficient of thermal expansion for Cu/Mo/Cu clad sheets fabricated by hot rolling

Orientation factor analysis of deformation mechanisms under special processing techniques in AZ31 magnesium alloys

The role of Goss-oriented texture for brass-type texture in nickel-based metals during cold rolling

Investigation on Grain Size Effect of Rolling Texture in Copper

Mechanism of and Key Technologies for Copper Bonding in the Hot Rolling of SCR Continuous Casting and Rolling

Crystal Plasticity Finite Element Simulation Study on Thread Rolling Pure Aluminum

An Investigation on Rolling Texture Transition in Copper Preprocessed by Equal Channel Angular Pressing

Tailoring the microstructure and mechanical properties of Cu-Fe alloy by varying the rolling path and rolling temperature

Analysis of Sheet Metal Forming (Stamping Process): A Study of the Variable Friction Coefficient on 5052 Aluminum Alloy

Characterization and modelling of evolving plasticity behaviour up to fracture for FCC and BCC metals

Modeling and analysis of deformation characteristics for the two-layered metal clad plate produced by asymmetric rolling