Abstract:Different amounts of Si element were introduced into binary Co50Cu50 alloy to investigate the thermodynamic properties and phase transitions of ternary Co50-x/2Cu(50-x)/2Si(x) (x = 10, 20, 30, 40 and 50 at%) alloys. Their liquidus and solidus temperatures versus Si content were determined by the differential scanning calorimetry (DSC) method. It was found that the addition of Si element depressed both the liquidus and solidus temperatures as compared with binary Co50Cu50 alloy. In particular, the additions of 10 and 20 at% Si remarkably reduced the critical undercooling for liquid demixing to only 3 and 1 K, whereas no liquid phase separation took place in other Co50-x/2Cu(50-x)/2Si(x) alloys. The relationship between the enthalpy of fusion and alloy composition was also established by a polynomial function on the basis of the measured data. The solidification microstructures of the DSC samples were investigated corresponding to the calorimetric signals, based on which the solidification pathway for each Co(50-x/)2Cu(50-x)/2Si(x) alloy was elucidated. The Si element displays stronger affinity with the Co element than the Cu element. As Si content rises, the pseudobinary eutectic (Co + Co2Si), (Co2Si + CoSi), (CoSi + CoSi2) and (Cu3Si + Si) structures were successively formed, and there were no ternary intermetallic compounds in these alloys. The thermal diffusivity of solid ternary Co50-x/2Cu(50-x)/2Si(x) alloys was determined by a laser flash method in a wide temperature range from 300 to 1180 K, which showed a decreasing tendency with the increase of Si content.

Thermodynamic Description and Simulation of Solidification Microstructure in the Co-Ti System

Experimental Investigation and Thermodynamic Calculations of the Co-Fe-Ti System

Experimental Study on Phase Relationships in the Co-rich Portion of the Co–Ti–Zr System

Thermodynamic Properties and Phase Transitions of Ternary Co–Cu–Si Alloys with Equiatomic Co/Cu Ratio

Phase separation and morphology formation of Co-Cu-Si ternary alloy

Phase Constitution and Microstructure Evolution of Rapidly Solidified Ti-Cu-Fe Alloy

Experimental Investigation of Phase Equilibria and Microstructure in the Co–Ti–V Ternary System

Experimental Investigation and Thermodynamic Calculation of Ti-Co-Hf System

Experimental Investigations of the Co–Ni–Ti System: Liquidus Surface Projection and Isothermal Section at 1373 K

Experimental investigation and thermodynamic descriptions of the Mo–Si–Ti system

A Thermodynamic Description of the C–Nb–Ti System over the Whole Composition and Temperature Ranges and Its Application in Solidification Microstructure Analysis

Thermodynamics and solidification kinetics of Ag–Ni–Co immiscible alloys

Experimental Determination of Phase Equilibria at 900°C and Liquidus Surface in the Cu-Ni-Ti System

Experimental Investigation, Thermodynamic Modeling and Solidified Microstructure of the Cu–Ti–Nb Ternary System

Experimental Phase Diagram, Thermodynamic Modeling and Solidified Microstructure in the Mo–Ni–W Ternary System

Experimental Investigation and Thermodynamic Calculation of the Phase Equilibria in the Cu-Fe-Ta System

Experimental Study and Thermodynamic Assessment of the Cu–Fe–Ti System

Experimental Investigation of Phase Equilibria in the Co-Ta-Si Ternary System

Experimental determination of isothermal sections for the Co-rich corner of the Co-Cr-Ti system at 800 and 900 °C

Thermodynamic Re-Assessment and Liquidus Projection of the Cu–Ni–Ti System

An Experimental Study and Themodynamic Evaluation of the Fe-Ti-W System at 1000°C