Abstract:This article investigates the microstructure evolution, phase formation, and magnetic properties of Co2FeCr0.5Alx (x = 0.9, 1.2) complex component alloys, as a function of heat treatment temperatures (at 500, 600, 700, and 1150°C), using XRD, optical microscopy, electron microscopy and vibrating sample magnetometry (VSM). The alloy with 20.4 at% Al (x= 0.9), identified here as C1, consisted of microscale BCC1 phase and BCC nanoscale particles containing mainly Fe and Cr, and B2 matrix with mainly Al and Co. Partial transformation of the BCC1 phase to an FCC phase was observed at 700°C and full transformation at 1150°C, through twinning. For the sample with 25.5 at% Al (x= 1.2), identified as sample C2, there were only nanoscale BCC particles in the B2 matrix with the same element segregation between the phases as C1. This increase in Al (from x= 0.9 to 1.2) content stabilised the B2 matrix phase, reduced the grain size, and increased both saturation magnetisation (Ms) and coercivity (Hc). Moreover, increasing the heat treatment temperature resulted in an increase in grain size of the B2 matrix, volume fraction and average size of the micro BCC 1 and nanoscale BCC phases for both C1 and C2, which also modified the soft magnetic properties, with Ms and Hc increasing up to 600°C followed by a decrease until 1150°C. Using the structural information as inputs for density functional theory calculations of Hc and Ms, it has been found that the Hc is influenced by the grain size of the matrix, and the volume fraction and size of the BCC1 phase at temperature higher than 600°C for C1 and 700°C for C2, but is controlled by nanoscale BCC particles below these temperatures. The Ms is controlled by the elemental diffusion and segregation. Thus, the best combination of Hc and Ms was seen with antiferromagnetic Cr segregated and partitioning in the microscale BCC1 phase, and a B2 matrix with less Cr rich precipitation, formed at 500°C, where the misfit strain between B2 matrix and nanoscale BCC was low.

Experimental determination of isothermal sections for the Co-rich corner of the Co-Cr-Ti system at 800 and 900 °C

Effect of Co Addition on the Phase Structure and Magnetic Properties of Fe-Si-Al Alloys

Experimental Investigation of Phase Equilibria in the Ti-Cr-V System at 1000–1200 °C

Experimental Study on Phase Relationships in the Co-rich Portion of the Co–Ti–Zr System

Experimental study of the phase relations in the Fe–Cr–Si ternary system at 700°C

Experimental Investigation of Phase Equilibria in the Co-Ta-Si Ternary System

Thermodynamic Description and Simulation of Solidification Microstructure in the Co-Ti System

Experimental determination of the liquidus projection of the B-Cr-Ti system

Homogenizing Effects of Co on Multi-Scale Elemental Distribution in Ru-containing Ni-based Single Crystal Superalloys

Phase equilibria in Co-Ti-Re ternary system

Structure and orientation of an intermetallic phase in a W-Ni-Co alloy

Experimental Investigation and Thermodynamic Calculations of the Co-Fe-Ti System

On the Solidification and Phase Stability of a Co-Cr-Fe-Ni-Ti High-Entropy Alloy

Influence of W, Mo and Ti trace elements on the phase separation in Al8Co17Cr17Cu8Fe17Ni33 based high entropy alloy

Experimental isothermal section of the system Cr-Nb-Ru at 1100 °C

First-principles calculations, experimental study, and thermodynamic modeling of the Al-Co-Cr system

Composition and phase structure dependence of magnetic properties for Co2FeCr0.5Alx (x=0.9, 1.2) multi principal component alloys

Phase equilibria in Co−Al−Re ternary system at 1100 and 1300 °C

The evolution of dual-phase core-shell structure and mechanical properties induced by Co addition in as-cast high-entropy intermetallic

Investigation of the Elemental Partitioning Behaviour and Site Preference in Ternary Model Nickel-Based Superalloys by Atom Probe Tomography and First-Principles Calculations

Understanding the composition-dependent stability of η phase for future Ni-Co-based superalloys