Abstract:In the nuclear reactor design, the critical heat flux (CHF) is one of the most important parameters for the reactor safety analysis. The occurrence of CHF will cause a sharp increase in the fuel rod surface temperature, which will result in the failure of fuel claddings and damage of the core. The CHF depends on the local flow conditions and the geometry of the flow channels, which makes the prediction of CHF in a fuel assembly more difficult when considering the cross flow between neighboring channels, spacer grids and mixing vanes. In this paper, the departure from nucleate boiling (DNB) type CHF in rod bundles under motion conditions is investigated based on the coupled analysis of the subchannel method and a CHF mechanism model, namely the liquid sublayer dryout model. The liquid sublayer dryout model assumes that there is a thin liquid sublayer underneath a vapor blanket formed by the coalescence of small bubbles near the heated wall. The dryout of this sublayer is considered as the CHF occurrence. In the liquid sublayer dryout model, sublayer thickness, velocity and length of the vapor blanket are three crucial parameters. In present research, the subchannel code calculates the local flow conditions for the rod bundle and provides input parameters for the liquid sublayer dryout model to predict CHF. In order to verify the method above, the predicted results are compared with the CHF Look-Up Table 2006 (LUT-2006) and a reasonable agreement can be achieved. In addition, the effects of rod bundle inlet coolant mass flow rate, subcooling and motion conditions on the CHF are analyzed.

A Mechanistic Bubble Crowding Model for Predicting Critical Heat Flux in Subchannels of a Bundle

Mechanistic Model of Critical Heat Flux in Rod Bundles Based on a High-Precision Subchannel Code

Assessment of a Theoretical Model for Predicting Forced Convective Critical Heat Flux in Rod Bundles

A Phenomenological CHF Model for Mixing-Vane Spacers in a Subchannel of a Rod Bundle

Experimental investigation and a mechanical model of critical heat flux in a narrow rectangular channel

Investigation on the Critical Heat Flux in Typical 5 by 5 Rod Bundle at Conditions Prototypical of PWR Based on CFD Methodology

Research on prediction of non-uniform heated rod bundle CHF based on subchannel analysis code coupling modified mechanistic model

Critical Heat Flux Prediction Model for Low Quality Flow Boiling of Water in Vertical Circular Tube

Researches in the Flow Modeling of Critical Heat Flux in Bundle

Prediction of Critical Heat Flux for Subcooled Flow Boiling in Annulus and Transient Surface Temperature Change at CHF

Prediction of critical heat flux in rod bowing geometries by coupled subchannel analysis and mechanistic model

Prediction of Critical Heat Flux in Rod Bundle Based on CFD Methodology

Fluid-to-fluid Modeling of Critical Heat Flux in 4×4 Rod Bundles

Numerical Investigation on Boiling Crisis in a Full-Length 5 × 5 Fuel Assembly under Typical Pressurized Water Reactor Conditions

Prediction of Critical Heat Flux (CHF) for the High-Pressure Region in Uniformly Heated Vertical Round Tubes

Study on the Prediction of DNB-Type Critical Heat Flux in Rod Bundle Under Motion Conditions

Investigation on the Critical Heat Flux in a 2 by 2 Fuel Assembly under Low Flow Rate and High Pressure with a CFD Methodology

Review of the AFD-type CHF Mechanistic Model and Its Application to Rod Bundle

Theoretical analysis of the characteristics of critical heat flux in vertical narrow rectangular channels under motion conditions

An improved mechanistic critical heat flux model and its application to motion conditions

CFD Investigation of the Cold Wall Effect on CHF in a 5 × 5 Rod Bundle for PWRs