Abstract:In vessel retention (IVR) is one of the key severe accident mitigation strategies to maintain reactor pressure vessel (RPV) integrity. IVR designs utilize the reactor pressure vessel lower head to contain molten fuel and rely on external reactor vessel cooling (ERVC) to remove decay heat. The capacity of ERVC is limited by the critical heat flux (CHF) of flow boiling on the outside of the reactor vessel surface. Therefore, the determination of critical heat flux (CHF) is crucial to predict whether the adoption of IVR would be successful in mitigating severe accidents. In 1999, Celeta et.al proposed a superheated layer vapor replenishment model. In this model they postulated that CHF would occur when the superheated layer was occupied by the vapor blanket coming into contact with the heated wall and they successfully predicted the critical heat flux in subcooled water flow boiling under high mass flux, high liquid subcooling and low/medium pressure conditions. To evaluate the practicability of this model in predicting CHF under IVR conditions, CHF experiments were performed under natural circulation conditions on the experiment facility "Test of External Vessel Surface with Enhanced Cooling" (TESEC). Experiments are conducted in a 30 mm wide, 61mm high rectangular flow channel with a 200 mm long heated surface along the flow direction. Two quartz windows are installed at the sidewalls of the flow channel for visualization. In order to simulate various positions of the reactor lower head, experiments at different inclination angles of the test section were conducted. The high speed visualization data at CHF point at various inclination angles were processed and analyzed by a MATLAB code developed by the author. The vapor blanket thickness at various inclination angles was measured from the visualization data and was also predicted by the Celeta model. By using geometry data from high speed images, CHF values were calculated by Celeta model and compared with the experimental results at various inclination angles. Limitations of the Celeta model in adaptation of predicting CHF under IVR conditions were further discussed.

Development of mechanistic model for CHF based on boiling crisis process

Experimental investigation and a mechanical model of critical heat flux in a narrow rectangular channel

Prediction of Critical Heat Flux for Subcooled Flow Boiling in Annulus and Transient Surface Temperature Change at CHF

A Critical Heat Flux Model for Saturated Flow Boiling on the Downward Curved Heated Surface

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Mechanistic Multidimensional Modeling of Forced Convection Boiling Heat Transfer

Separate factors’ effects on CHF for flow boiling in an inclined rectangular channel under low mass flux

Assessment of CHF and Post-CHF Heat Transfer Models for High-Pressure Condition

Experimental and Analytical Study on the Influence of Saturation Pressure and Surface Roughness on Pool Boiling CHF of HFE-7100

Theoretical model for subcooled upward flow boiling heat transfer and critical heat flux for an inclined downward heated surface

Development of a new semi-mechanistic wall boiling heat transfer model for CFD methodology focusing on macroscopic parameters

CHF experiments and prediction model under subcooling flow boiling condition in passive IVR-ERVC system

Existing DNB-type CHF mechanistic models and relations with visualized experiments in forced convective flow boiling: A review

Prediction Of subcooled water flow boiling critical heat flux (CHF) at low pressure

A Theoretical Model to Predict Pool Boiling CHF Incorporating Effects of Contact Angle and Orientation

On the Critical Heat Flux Assessment of Micro- and Nanoscale Roughened Surfaces

Numerical Investigation of Flow Boiling Characteristics in Narrow Rectangular Channels Using Two-Fluid Eulerian Cfd Model Covering a Wide Range of Pressures

Predictive Modeling for Microchannel Flow Boiling Heat Transfer under the Dual Effect of Gravity and Surface Modification

On the prediction of critical heat flux using a physics-informed machine learning-aided framework

Augmentation of Flow Boiling Critical Heat Flux along Microchanneled Surfaces

Development of a heat transfer model for the film boiling regime in a fouling layer