Abstract:Heat transfer in a turbocharger plays a crucial role in the optimization of turbocharger-engine matching process. Due to high temperature gradients between the hot exhaust gas compared to the compressor as well as the environment, it is well-known, that the heat loss from a turbocharger turbine is significant. Investigations of turbocharger performance are commonly done by quantifying the performance parameters under adiabatic conditions, following the paradigm of the first law of thermodynamics, based on the energy balance method. It turns out that an adiabatic assumption and the energy balance method is insufficient to provide a deep understanding about the aerothermodynamic effects on the turbine performance due to heat transfer. Based on the current state-of-the-art, this study aims to improve the characterization methods for passenger car turbocharger turbines, considering the impacts of heat transfer. Firstly, the turbocharger is measured on a hot gas test bench. Based on this experimental data, the turbine heat transfer is being quantified through implementing a new innovative power-based approach. Consequently, a heat loss free turbine performance map can be derived. Secondly, a CFD analysis is performed on selected operating points, taking turbine housing temperature measurements as boundary conditions. CFD results are verified and validated by using the experimental data, both at adiabatic and diabatic test conditions. Finally, a flow exergy-based method is being applied to the predicted 3D flow field from the CFD simulation. This approach allows to identify and quantify the aerothermodynamic impacts of heat transfer on the turbine performance for cases with and without heat loss, considering both first and second laws of thermodynamics. This study aims to enhance our understanding of the underlying thermo-fluid physics in a turbocharger turbine associated with heat loss. It will also demonstrate the potential of the application of flow exergy method to 3D CFD data, rather than limited to 1D adiabatic models in current engine research and development.

Influence of aerodynamic characteristics optimization of exhaust passage on heat transfer of condenser in steam turbine

Multi-Factor Optimization Study on Aerodynamic Performance of Low-Pressure Exhaust Passage in Steam Turbines

Influence of Water Spray Parameters on Aerodynamic Characteristics and Temperature Drop Characteristics of Exhaust Passage in Steam Turbine

Study on heat transfer and friction characteristics in fin-tube heat exchangers used for electrical machines cooling

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Experiment on Forced Convection-Condensation Heat Transfer Characteristics Based on Finned Plate Configuration

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Aerodynamics Analysis of Superheated Steam Flow Through Multi-Stage Perforated Plates

Thermal analysis and performance investigations of shell and tube heat exchanger using numerical simulations

Numerical study on the complicated flow filed of steam turbine condenser throat

Numerical Study on the Outlet Flow Field of the 300MW Steam Turbine’s Condenser Throat with Flow Guide Devices

Research on fluid flow and heat transfer characteristics in a three-dimensional condenser

Research on Economy Optimization of Heat Recovery System after Steam Turbine Flow Path Retrofit

Experimental and Numerical Investigation of a Turbocharger Turbine Using Exergy Analysis at Non-Adiabatic Conditions

Experimental Measurement and Analysis of Performance of Heat Pipe Heat Exchanger Used in a Turbocharged Engine with Intercooling

Comprehensive performance investigation and optimization of a plate fin heat exchanger with wavy fins

Inundation Correlation Research on the Simulation of Two-Phase Flow and Heat Transfer in a Condenser

Numerical simulation of heat transfer performance of different heat exchange tubes in heat recovery steam generator

Dynamic Simulation of Heat and Mass Transfer Characteristics for Tube-finned Heat Exchangers under Dehumidifying Conditions

Enhancing heat transfer efficiency in corrugated tube heat exchangers: A comprehensive approach through structural optimization and field synergy analysis

A Review on the Research of Flow and Heat Transfer in Steam Condensing