Abstract:This paper researches the heat transfer equation and thermal balance equation of a shell-and-tube evaporator; constructs an accurate mathematical model for the evaporator; and derives equations including detailed and accurate calculation methods for all heat transfer coefficients, such as the refrigerant side heat transfer coefficient, water side heat transfer coefficient, refrigerant kinematic viscosity, density, and specific enthalpy. Adopting this approach involves fitting the relationships between the density, thermal conductivity, kinematic viscosity, and enthalpy of R134a refrigerants in saturated vapor and liquid states. The relationships between superheated gas enthalpy, density, and temperature were also assessed, and heat transfer coefficients were obtained through calculation methods and microelement heat transfer relationships in both the single-phase and two-phase zones, matching empirical formulas concerning the relationship between superheated enthalpy and temperature. Notably, the research utilizes the Simulink approach without relying on M files and S functions to establish the evaporator's two-phase and superheated zones, as well as an overall simulation model which provides intuitive internal coupling relationships and the coefficient calculation process in the formulas and uses the function "Algebraic Constraint" instead of "memory" or "1/z" to solve algebraic loops, thereby avoiding computation deviations introduced by delays and iterations. Finally, simulation calculations were conducted, and an experimental platform was designed and built for experimental verification which can validate the derived mathematical models. The simulation results, including the evaporator pressure, and chilled water outlet temperature with variation in chilled water mass flow rate, closely matched the experimental outcomes. The simulation model is concise and intuitive. Modifying parameters such as the thermal conductivity of the model material is straightforward, thereby alleviating the workload for researchers. It also facilitates an understanding of model principles for beginners. Moreover, the database generated from the model allows for fault analysis, diagnosis, and decision evaluation.

Inundation Correlation Research on the Simulation of Two-Phase Flow and Heat Transfer in a Condenser

Research on fluid flow and heat transfer characteristics in a three-dimensional condenser

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Thermal analysis and performance investigations of shell and tube heat exchanger using numerical simulations

Heat transfer characteristics in vertical tube condensers: Experimental investigation and numerical validation

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Numerical simulation on the header-orifice structure-based liquid-vapor separator used in liquid-separation condenser

Analysis of wave influence on steam condensation with non-condensable gases using cfd

Improved CFD simulation of water hammer caused by condensation with an enhanced phase change model

Improvement of Condensation Model With the Presence of Non-Condensable Gas for Thermal-Hydraulic Analysis in Containment

Homogeneous/heterogeneous Condensing Flow Modeling in Turbine Cascades

Numerical Investigation of Convective Condensation with the Presence of Non-Condensable Gases in A Vertical Tube

CFD simulation on hydrodynamic and thermal behavior of elliptical condensing tubes with an improved mass transfer model

Modeling Method for Overheated Zone and Two-Phase Zone of Dry Shell-and-Tube Evaporator in Ship Air Conditioning

Study of Condensation during Direct Contact between Steam and Water in Pressure-Relief Tank

Analysis of the multiphase flow with condensation in the two-phase ejector condenser using CFD modeling

Modeling and experimental study of air-cooled finned-tube condenser using coupled distribution parameter method and air-side temperature distribution

Sensitivity analysis of velocity field influence on condensers' performance and parallel circuit design based on actual air velocity distribution

Numerical Simulation on Heat and Mass Transfer of Plate Evaporative Condenser

Numerical Investigation of Air-Steam Condensation in a Vertically Enhanced Tube with Concave and Convex Surfaces

A numerical study on convective condensation of flue gas in tubular heat exchangers