Abstract:Direct contact condensation (DCC) is a phenomenon observed when steam interacts with subcooled water, exhibiting higher heat and mass transfer rates compared to wall condensation. It has garnered significant interest across industries such as nuclear, chemical, and power due to its advantageous characteristics. In the context of pressure-relief tanks, understanding and optimizing the DCC process are critical for safety and efficiency. The efficiency of pressure-relief tanks depends on the amount of steam condensed per unit of time, which directly affects their operational parameters and design. This study focuses on investigating the direct gas–liquid contact condensation process in pressure-relief tanks using computational fluid dynamics (CFD). Through experimental validation and a sensitivity analysis, the study provides insights into the influence of inlet steam parameters and basin temperature on the steam plume characteristics. Furthermore, steady-state and transient calculation models are developed to simulate the behaviour of the pressure-relief tank, providing valuable data for safety analysis and design optimization. There is a relatively high-pressure area in the upper part of the bubble hole of the pressure-relief tube, and the value increases as it is closer to the holes. The steam velocity in the bubbling hole near the 90° elbow position is higher. This study contributes to the understanding of steam condensation dynamics in pressure-relief tanks. When the steam emission and pressure are fixed, the equilibrium temperature increases linearly as the initial temperature increases (where a = 1, b = 20 in y = a x+ b correlation), the equilibrium pressure increases nearly exponentially, and the equilibrium gas volume decreases. When the steam emission and initial temperature are fixed, the equilibrium temperature does not change as the steam discharge pressure increases. The correlations between the predicted equilibrium parameters and the inlet steam parameters and tank temperature provide valuable insights for optimizing a pressure-relief tank design and improving the operational safety in diverse industrial contexts.

Analysis of wave influence on steam condensation with non-condensable gases using cfd

A CFD Study of Wave Influence on Film Steam Condensation in the Presence of Non-Condensable Gas

Analysis Of Effects Of Buoyancy Force On Steam Condensation With Non-Condensable Gases In A Rectangular Channel

Numerical Analysis of Heat Transfer Characteristics of a Falling Film Type Plate-Fin Condenser/Reboiler

Improvement of Condensation Model With the Presence of Non-Condensable Gas for Thermal-Hydraulic Analysis in Containment

Numerical study on the condensation characteristics of vapor with non-condensable gas on inclined walls inside containment

CFD Modeling of Film Condensation from a Steam-Air Mixture in Vertical Channels

Numerical investigations on the component separation phenomenon and transport behavior of steam-air-hydrogen mixture induced by condensation

Numerical Investigation of Convective Condensation with the Presence of Non-Condensable Gases in A Vertical Tube

Numerical simulation on the effect of non-condensable gas on direct contact condensation of steam jet in a narrow pipe

Improved CFD simulation of water hammer caused by condensation with an enhanced phase change model

CFD simulation of water vapour condensation in the presence of non-condensable gas in vertical cylindrical condensers

Numerical Investigation of Natural Convective Condensation with Noncondensable Gases in the Reactor Containment after Severe Accidents

Effects of Liquid Film Waviness, Suction, and Fog Formation on Condensation in the Presence of Noncondensable Gases

Numerical investigation on submerged steam jet condensation in subcooled water flow in a restricted channel with the presence of non-condensable gas

Numerical simulation study on heat transfer characteristics of steam condensation in the presence of multi-component non-condensable gas outside the tube bundle

Assessment of steam condensation model with the presence of non-condensable gas in a vertical tube using RELAP5 Mod 3.2 code and MIT exp. Data

Boundary layer measurements for validating CFD condensation model and analysis based on heat and mass transfer analogy in laminar flow condition

Steam Condensation Heat Transfer in the Presence of Noncondensable Gases (NCGs) in Nuclear Power Plants (NPPs): A Comprehensive Review of Fundamentals, Current Status, and Prospects for Future Research

Study of Condensation during Direct Contact between Steam and Water in Pressure-Relief Tank

Effect of Non-Condensation Gas on Heat Transfer of Direct Contact Condensation