Abstract:A series of experiments has been conducted to investigate the tribological properties of a TiN film sliding against GCr15 steel balls in ambient air, low vacuum and high vacuum environments. Various friction loads and sliding velocities were also applied. The TiN film displays a steady-state friction stage after the running-in stage in all the above environments, while the durations of running-in stages are different. The steady-state friction coefficients of the TiN film were around 0.56 in ambient air and 0.3 in the high vacuum environment (1 × 10−5 mbar). In the low vacuum (1 × 10−2 mbar) environment, a low friction coefficient (around 0.19) was attained for all the friction tests on TiN film, irrespective of the applied load and sliding velocity. In the meantime, it was noticed that the applied loads and the sliding velocities would change the duration of the running-in stage before reaching the low friction coefficient. It is revealed by the analysis of wear tracks that the metal oxides induced by the tribo-chemical effect at the friction interface play an important role in affecting the tribological behaviors of the TiN films in different environments. The Raman results show that the main component of the metal oxides is hematite (α-Fe2O3), and the amount of iron oxide is related to the friction environment. The composition and quantity of iron oxides produced by the interfacial tribo-chemical effect affect the tribological behavior. The results also show that the mechanical wear process at the friction interface displays a polishing effect, which would reduce the surface roughness. The mechanical wear performance varies under different loads and velocities. The tribological tests results indicate that the interfacial tribo-chemical effect and mechanical wear process should be considered together rather than individually to interpret the tribological behaviors of TiN films in different environments.

TRIBOLOGICAL INVESTIGATION OF BORON CARBIDE FILMS SLIDING AGAINST DIFFERENT MATING MATERIALS UNDER HIGH RELATIVE HUMIDITY

Micro-Tribological Behavior of Boron Carbide Self-Mated Pairs

Microstructure and tribological performance of Co-B intermetallic compounds under water environment

Unraveling the Effects of Boron Incorporated on Tribological Properties of Amorphous Carbon Film under Water Lubrication

Influence of Tribofilm on Superlubricity of Highly-Hydrogenated Amorphous Carbon Films in Inert Gaseous Environments

Differences in Tribological Behaviors upon Switching Fixed and Moving Materials of Tribo-pairs including Metal and Polymer

Tribological Properties of Cr(Si)CN Coatings Sliding Against Different Mating Balls in Water

Mechanical and tribological property of Cu/CrB 2 composites under dry sliding condition

Tribological behaviors of Mo2BC ceramics against various counterpart materials

Microstructure, Mechanical and Tribological Properties of CrSiC Coatings Sliding Against SiC and Al2O3 Balls in Water

Investigation of the preparation and tribological behavior of a frictional interface covered with sinusoidal microchannels containing SnAgCu and Ti3SiC2

Simultaneously enhancing mechanical and tribological performance in undercooled Co-18.5 at. % B alloys

A tribological investigation of SLM fabricated TC4 titanium alloy with carburization pre-treatment

Dry sliding friction and wear properties of B4C particulate-reinforced Al-5083 matrix composites

The Role of Products of Tribochemical Reactions on the Friction and Wear Properties of Alumina/silicon Carbide Couple Sliding in HFC-134a Gas

Effect of Relative Humidity on the Tribological/conductive Properties of Cu/Cu Rolling Contact Pairs

Tribological behavior of h -BN/Al 2 O 3 self-lubricating composites in extreme environments–Part I: Lubricating behavior and ultra-low friction coefficient mechanism in air environments from room temperature to 1200 °C

Friction and wear characteristics of the nanolaminated ternary transition metal boride: Mn2AlB2

Effect of grain size on tribological behavior of hot‐pressed boron carbide sliding against alumina balls

Effect of different working conditions on tribological behaviors of PcBN/440c stainless steel in vacuum environment

Influence of Interfacial Tribo-Chemical and Mechanical Effect on Tribological Behaviors of TiN Film in Different Environments