Abstract:Pt-modified aluminide coating has attracted great attention due to its advantage of the integrated property in resisting both high temperature oxidation and hot corrosion. By the presence of Pt, the spallation trend of the grown oxide scale and the detrimental effect of S can be restrained at a very low level. Besides, Pt could promote alpha-Al2O3 formation and stabilize beta-NiAl phase. Thus Pt-modified aluminide (Pt-Al) coating has been widely used in some crucial applications requiring reliability and extended service life. There are mainly PtAl2, beta-(Ni, Pt) Al and gamma/gamma'-NiPtAl phases existing inside Pt-Al coating. In this work, a single phase PtAl2 coating was prepared on a Ni-based K38G superalloy through pulse-electroplating of Pt and pack aluminization under stepped heating mode. At 1100 degrees C, the isothermal oxidation behavior of the single phase PtAl2 coating was evaluated by thermogravimetric analysis (TGA). Cyclic oxidation test of the PtAl2 coating was performed within a vertical muffle furnace at the same temperature. The results indicate that the singular PtAl2 coating possesses quite good isothermal oxidation resistance. However, its resistance against cyclic oxidation is very poor. The cyclic stress induced by repeated heating and cooling has caused visible detachment of PtAl2 coating layer, and the spallation of PtAl2 in further would lead to a premature failure of the whole coating system. Partial spallation of PtAl2 layer, including undesirable consumption of Al inside beta-NiAl nearby the spallation acts the main reason responsible for the final failure. Accordingly, it is not appropriate to apply single phase PtAl2 coating in the high temperature services involving stress and load. The degradation mechanism of the singular PtAl2 coating is investigated by discussing the stress generated from cyclic heating and cooling.

High-temperature Performance of (ni,pt)al Coatings on Second-Generation Ni-base Single-Crystal Superalloy at 1100 °C: Effect of Excess S Impurities

Influences of MCrAlY Coatings and TBCs on Oxidation Behavior of a Ni-Based Single Crystal Superalloy

High-temperature performance of Pt-modified Ni-20Co-28Cr-10Al-0.5Y coating: Formation mechanism of Pt-rich overlayer and its effect on thermally grown oxide failure

Effect of Pt modification on hot corrosion resistance of NiCrAlYSi+AlY coating at 900 °C

Oxidation Behavior and Oxide Transformation of a Pt-Modified Aluminide Coating at Moderate High Temperature

Effect of coatings on oxidation behavior of a fourth generation Ni-based single crystal superalloys at ultra high temperature

Oxidation Performance and Interdiffusion Behavior of a Pt-Modified Aluminide Coating with Pre-deposition of Ni

Effect of Pt on Stress Rupture Properties of Pt-Modified Nickel Aluminide Coatings at 1100 °C

Oxidation Property and Failure Mechanism of A Single Phase Ptal2 Coating

Microstructure Analysis of Initial Alumina of Pt-Modified Aluminide Coatings on Ni-Based Alloy

High-temperature Oxidation Behaviour of Refurbished (ni,pt)al Coating on Ni-based Superalloy at 1100 °C

High-temperature Corrosion Behaviour of Pt-modified Aluminide Coating with Solid NaCl Deposit in O2 + 10 Vol% H2O and the Influence of Pre-Oxidation Treatment

Diffusion Characteristics and Structural Stability of Pt Modified Β-Nial/γ′-ni3al Within NiCoCrAl Alloy at High Temperature

Cyclic oxidation behavior of Pt modified NiCoCrAlYHfZr + AlNiY coating on a Ni-based single crystal superalloy

Effect of Nickel Aluminide Microcrystalline Coating on High-Temperature Oxidation Behavior of NiAl-33.5%Cr-0.5%Zr Alloy

Effect of Pt-rich Position on the Hot Corrosion Behavior of NiCoCrAlY Coating for a Single-Crystal Superalloy

Improving Cyclic Oxidation Resistance of Ni3Al-based Single Crystal Superalloy with Low-Diffusion Platinum-Modified Aluminide Coating

Modification of NiCoCrAlY with Pt: Part I. Effect of Pt Depositing Location and Cyclic Oxidation Performance

High-Temperature Corrosion Behaviour of Pt-Modified Aluminide Coating under the Effect of Nacl Plus Water Vapour and the Influence of Pre-Oxidation Treatment

Impact of Pt/Al ratios on the cyclic oxidation and TCP precipitation of β-(Ni, Pt)Al coated superalloy at 1150 °C

A Magnetron Sputtered Microcrystalline Β-Nial Coating for SC Superalloys. Part II. Effects of a NiCrO Diffusion Barrier on Oxidation Behavior at 1100 °C