Abstract:Si-modified NiAl coating has been studied by researchers due to its good performance in high temperature corrosive environment, but the effect of Si content on the high temperature oxidation resistance of the aluminide coatings has been seldom studied. To figure out this issue, three modified NiAl coatings with different Si contents were prepared by varying the Si contents 8wt%, 17wt% and 30 wt% in the slurry. Phase structures and microstructures of the simple NiAl coatings and three Si-modified NiAl coatings before and after oxidation were analyzed by XRD, SEM and EPMA, etc. The results show that the delta-Ni2Al3 and ss-NiAl are the primary phases of the four aluminide coatings. Si mainly locates in the upper zone of the Si-modified NiAl coatings in the form of silicides as CrSi2, Cr5Si3 and Ni2Si. After oxidation at 1000. for 500 h, the simple NiAl coating has the maximum mass gain of 1.93 mg/cm(2), while the Si-modified NiAl coating with Si content of 8wt% has the smallest mass gain. The dopant of Si into NiAl coatings can promote the formation of protective alpha-Al2O3 film, retard the outward diffusion of refractory metal elements and improve the surface quality of the oxide film, resulting in reduced oxidation rate. However, the addition of Si reduces the Al content on the surface layer of the coating and may make the coating insufficient of ss phase to maintain the selective oxidation of Al in the later period of long- time oxidation. Therefore, when the Si content is 8wt%, the Si-modified NiAl coating possesses the best oxidation resistance.

The Effects of Alloying Elements Cr, Al, and Si on Oxidation Behaviors of Ni-Based Superalloys

High Temperature Oxidation Resistance and Degradation Mechanism of Al-Si Coatings on Nickel-Based Superalloy at 1000.

Study on the high-temperature oxidation of AlCrFeCoNi-based high-entropy alloys with trace Si additions

Effects of Ni and Cr on the high-temperature oxidation behavior and mechanisms of Co- and CoNi-base superalloys

Effect of aluminium and silicon on high temperature oxidation resistance of Fe-Cr-Ni heat resistant steel

Effects of Al/Si on the oxidation behavior of a TiZrV0.5Nb0.5 refractory high entropy alloy at 1000 °C

Oxidation behavior of AlCoCrFeNiSi high-entropy alloys at 1100 °C

Effect of Ni in SiO 2 coating on the oxidation resistance of TiAl alloy at 900 °C

Enhancing oxidation resistance with Si in Fe36Ni36Al15Cr10Si2Mo1 multi-principal element alloy at 700 °C

Effect of Nickel Aluminide Microcrystalline Coating on High-Temperature Oxidation Behavior of NiAl-33.5%Cr-0.5%Zr Alloy

Isothermal Oxidation Resistance of As-cast NiAl and NiAl-(Cr, Mo) Eutectic Alloys at 1000°C

The synergy effect of elements on the oxidation resistance of a high-purity directionally solidification nickel-based superalloy

Comparative study of the reactive elements effects on oxidation behavior of a Ni-based superalloy

Effect of Cr and W addition on the oxidation behavior of Ni–8%Al alloy at 1000 °C

Oxidation behavior of a nickel-based single crystal superalloy at 1100 °C under different oxygen concentration

Effect of Al content on the oxidation behavior of NiCoCrAlYHf alloys at 1100°C

Corrosion Behavior of Newly Designed Fe-Ni-Base Alloys in High-Temperature CO2 at 700 °C

Effect of Pre-Oxidation on High-Temperature Oxidation Behavior of Al-Si Coating on Nickel-Based Superalloy

The Effect of Nb, Ta, and Ti on the Oxidation of a New Polycrystalline Ni-Based Superalloy

High-throughput experiment-assisted study of the alloying effects on oxidation of Nb-based alloys

Effect of Alloying Additions on Oxidation Behaviors of Ni‐Fe Based Superalloy for Ultra‐Supercritical Boiler Applications