Abstract:For the fabrication of high-strength carbon nanotube (CNT) reinforced Al matrix composites, the uniform dispersion, strong interface bonding and high structural integrity of CNTs have been regarded as the three most important issues. In this work, two distinct approaches, namely high shear dispersion (HSD) and shift-speed ball milling (SSBM), were applied to disperse CNTs (1.5 wt%) into pure Al powders. These two kinds of CNT/Al composite powders as well as the pure Al powder (as a comparison) were deposited onto stainless steel plates by cold spraying using different processing parameters. The velocity and the temperature of the particle prior to impact was simulated by the commercial code of Fluent. The deposition efficiency, microstructure evolution, as well as the distribution and structural integrity of CNTs in the composite coatings produced from different starting powders were comparatively investigated in terms of X-ray diffraction (XRD), Raman spectra, and electron back scanning diffraction (EBSD). According to the XRD and Raman analysis, no new phases such as oxides or brittle Al4C3 were detectable in both CNT/Al composite coatings. Some structural damages of CNTs were found in both composite coatings, especially the one fabricated from HSD composite powder. The dispersion of CNTs onto Al particle surfaces by HSD approach did not achieve a significant strengthening effect on the composite coatings, but adversely affected the metallic bonding of the particles and the substrate. The microhardness of the CNT/Al composite coating produced from SSBM powders reached around ~115 HV0.1, showing a significant improvement compared to the pure Al coating mainly due to the grain refinement and CNTs strengthening.

Fabrication and Mechanical Properties of CNT/Al Composites Via Shift-Speed Ball Milling and Hot-Rolling

Carbon-nanotube-templated Carbon Nanofibers with Improved Mechanical Performance

Evolution of Microstructure and Mechanical Properties of CNTs/Al-Mg Composites Prepared by Powder Metallurgy

Effects of the addition of CNTs and Al alloying on the microstructure and properties of Cu-(Al)/CNTs composites

Study on the Properties of Carbon Nanotube (CNTs) Reinforced AlSi10Mg Composites Fabricated by Powder Metallurgy

Al/CNT nanocomposite fabrication on the different property of raw material using a planetary ball mill

Balanced strength and ductility in CNT/Al composites achieved by flake powder metallurgy via shift-speed ball milling

CNT-induced heterogeneous matrix grain structure in CNTs/Al composites

Fabrication and tribological properties of carbon nanotubes reinforced Al composites prepared by pressureless infiltration technique

Mechanical properties of CNT-reinforced Ni3Al composites: the role of chirality, temperature, and volume fraction

Fabrication and Tribological Properties of Carbon Nanotubes-Aluminum Composites

Synthesis of carbon nanotube reinforced Al matrix composite coatings via cold spray deposition

The enhanced mechanical properties and strain-hardening capability of CNT/Al composites achieved by heterogeneous micro-laminated architecture

Developing Fittingly Comprehensive Performance Carbon Nanotube/Mg-6Zn Sheets with Substantial Enhancement in Formability

Study on the Mechanism of CNTs Regulating the Microstructures and Properties of Al–Cu–Mg Alloy

Effect of Carbon Nanotube Orientation on Mechanical Properties and Thermal Expansion Coefficient of Carbon Nanotube-Reinforced Aluminum Matrix Composites

Effect of powder microstructure on the thermal and mechanical properties of hot extruded Al-CNT composite

Microstructures, thermal and mechanical properties of Al–Si-CNT composites for thermal management applications

Evolution of Microstructure, Texture and Mechanical Properties for Multilayered Al Matrix Composites by Accumulative Roll Bonding

Remarkable improvement of mechanical properties of layered CNTs/Al composites with Cu decorated on CNTs

Strengthening and toughening mechanisms of CNTs/Mg–Al composites prepared via powder metallurgy combined with hot extrusion