Abstract:This study reports the manufacture, microstructure, and tribological behaviour of carbon nanotube reinforced aluminium composites against pure aluminium. The specimens were fabricated using powder metallurgy method. The nanotubes in weight percentages of 0.5, 1.0, 1.5, and 2.0 were homogeneously dispersed and mechanically alloyed using a high energy ball milling. The milled powders were cold compacted and then isothermally sintered in air. The density of all samples was measured using Archimedes method and all had a relative density between 92.22% and 97.74%. Vickers hardness increased with increasing CNT fraction up to 1.5 wt% and then reduced. The microstructures and surfaces were investigated using high resolution scanning electron microscope (SEM). The tribological tests showed that the CNT reinforced composites displayed lower wear rate and friction coefficient compared to the pure aluminium under mild wear conditions. However, for severe wear conditions, the CNT reinforced composites exhibited higher friction coefficient and wear rate compared to the pure aluminium. It was also found that the friction and wear behaviour of CNT reinforced composites is significantly dependent on the applied load and there is a critical load beyond which CNTs could have adverse impact on the wear resistance of aluminium.

Fabrication and tribological properties of carbon nanotubes reinforced Al composites prepared by pressureless infiltration technique

Fabrication and Tribological Properties of Carbon Nanotubes-Aluminum Composites

Tribological properties of carbon nanotube-doped carbon/carbon composites

Micro/Nanostructure and Tribological Characteristics of Pressureless Sintered Carbon Nanotubes Reinforced Aluminium Matrix Composites

SYNTHESIS AND THE PERFORMANCE OF CARBON NANOTUBES-(Ni-P) COMPOSITES

Preparation and Tribological Properties of the Carbon Nanotubes–ni–p Composite Coating

Fabrication and Mechanical Properties of CNT/Al Composites Via Shift-Speed Ball Milling and Hot-Rolling

Processing and Properties of Carbon Nanotubes Reinforced Aluminum Composites

Tribological properties of carbon-nanotube-reinforced copper composites

Tribological Properties of Carbon Nanotube-Reinforced Composites

Understanding the Influencing Mechanism of CNTs on the Microstructures and Wear Characterization of Semi-Solid Stir Casting Al-Cu-Mg-Si Alloys

Tribological Application of Carbon Nanotubes in a Metal-Based Composite Coating and Composites

Study on the Properties of Carbon Nanotube (CNTs) Reinforced AlSi10Mg Composites Fabricated by Powder Metallurgy

Preparation, microstructure and properties of Cu-8.3Al/CNTs composites with different volume fractions of CNTs

Microstructure Evolution and Wear Characterization of Cnts/Al-Cu-Mg-Si Nanocomposites Manufactured Using Semi-Solid Stir Casting

Fabrication of aluminum–carbon nanotube composites and their electrical properties

Preparation and characterization of carbon nanotubes/aluminum matrix composites

Effect of Carbon Nanotube (CNT) Content on the Properties of In-Situ Synthesis CNT Reinforced Al Composites

Tribological performance of Graphene/Carbon nanotube hybrid reinforced Al2O3 composites

Preparation of Ni-Cnt Composite Coatings on Aluminum Substrate and Its Friction and Wear Behavior