Abstract:During thermomechanical processing of wrought magnesium alloys, the microstructure and texture continue to evolve as dynamic recrystallization (DRX) proceeds. New grains generated by DRX with a low dislocation density also participate in the texture evolution as the strain increases. However, the controlling mechanisms that drive the evolution are not yet understood. In this work, we studied texture evolution in an extruded Mg–Al–Mn alloy (AM30) during uniaxial compression at 450°C and under various strain rates (ε̇<1.0s-1). The tests were performed along the extrusion direction (ED) and the radial direction (RaD), respectively. Texture evolution was examined by electron backscatter diffraction and X-ray diffraction at different strains. At ε̇<0.1s-1, the effect of twinning was negligible. At ε̇=0.5s-1, a high volume fraction of twins were activated but the twins were consumed by DRX as the strain increased. At ε̇=0.8s-1, twins were not completely consumed by DRX, and the remaining twins had highly incoherent twin boundaries and contributed to the texture. In compression along the ED and with strain rates of ⩽0.5s−1, prismatic slip dominated the texture evolution, and the final orientations clustered around 〈101‾0〉‖ED and〈21‾1‾0〉 || ED, resulting in two stable orientations with a 30° misorientation. At 0.8s−1, basal and pyramidal slip began to dominate the texture evolution at larger strain. In compression along the RaD, basal and pyramidal slip dominated the texture evolution, creating a texture located near 〈101‾2〉–〈101‾5〉–〈21‾1‾9〉–〈21‾1‾5〉and〈101‾0〉–〈21‾1‾0〉 in the inverse pole figure. Texture simulations based on the Sachs and the viscoplastic self-consistent models show a satisfactory correlation between texture evolution and deformation modes.

Texture Evolution of Magnesium Alloy AZ31 During High Temperature Tensile Deformation

Microstructure Evolution of AZ31B Magnesium Alloy Sheets Deformed in Different Deformation Directions

Evolution of Microstructure and Texture During Uniaxial Compression of Cast AZ31Mg Alloy at Elevated Temperatures

Microtexture Evolution Via Deformation Twinning and Slip During Compression of Magnesium Alloy AZ31

Microstructure Evolution During High Strain Rate Tensile Deformation of A Fine-Grained Az91 Magnesium Alloy

Tensile Properties, Texture Evolutions and Deformation Anisotropy of As-Extruded Mg-6Zn-1Zr Magnesium Alloy at Room and Elevated Temperatures

Texture Evolution and Deformation Activity of an Extruded Magnesium Alloy: Effect of Yttrium and Deformation Temperature

Evolutions of Microstructure and Microtexture in Az21 Mg Alloy During Multi-Directional Forging under Decreasing Temperature Conditions

STRAIN-INDUCED TEXTURE DEVELOPMENT IN THE MAGNESIUM ALLOY AZ31

Evolution of microstructure and texture of AZ80 magnesium alloy under hot torsion with constant decreasing temperature rate

Effect of Original Orientation on Microtexture Evolution of Az31 Mg Alloy

Microstructural Evolution of Ultra-Fine Grained Mg-6.62Zn-0.6Zr Alloy on the Basis of Adiabatic Rise in Temperature under Dynamic Loading

Effect of texture types on microstructure evolution and mechanical properties of AZ31 magnesium alloy undergoing uniaxial tension deformation at room temperature

Microstructure and Texture Evolution of Az31 Magnesium Alloy During Large Strain Hot Rolling

Texture Evolution During Dynamic Recrystallization in a Magnesium Alloy at 450 °C

Dynamic Recrystallization and Texture Development During Hot Deformation of Magnesium Alloy AZ31

Microstructural Evolution of Az61 Magnesium Alloy During Hot Deformation

Mechanical Properties and Microstructure Evolution of AZ31 Magnesium Alloy Sheet Subjected to High Strain Rates Loading of Different Orientations

Mechanical Properties and Microstructure of As-Extruded AZ31 Mg Alloy at High Temperatures

Texture Evolution of Extruded AZ31 Magnesium Alloy Sheets

Texture Weakening of AZ31 Magnesium Alloy Sheet Obtained by a Combination of Bidirectional Cyclic Bending at Low Temperature and Static Recrystallization