Abstract:Microfluidics, as an emerging technology, is highly dependent on the evolution of device materials and fabrication techniques. While replica molding of polydimethylsiloxane and hot embossing/injection molding of thermoplastics are most popular, they are either hard to scale up or inappropriate for laboratory-scale prototyping. Recently, photocurable resins, as a huge class of materials, have attracted extensive interest. However, very few of them can now be used in device fabrication due to the challenge in machining these materials. In response, we herein propose a novel concept of composite elastomers, which can covalently link with and consequently offer a flexible support to photocured thin films. This effect would allow most photocurable resins to be used in microfluidic device fabrication, greatly enriching the material choices for diverse applications. Moreover, the whole fabrication process becomes very simple and rapid, with an impressive throughput of at least hundreds of replicas per day. With these features, it is reasonably expected that the composite elastomer-enabled rapid photofabrication method will be very competent for laboratory prototyping, providing not only the ease of fabrication but also a possibility to select the materials specifically for ultimate applications and promising potential for volume production without the redevelopment process. These may offer a good opportunity to narrow the current gap between academic research and industrial practice.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c06143.Movies showing the flexibility of the composite elastomer, process of composite elastomer-enabled photofabrication of the microfluidic device, generation of W/O/W double emulsion droplets, and operation of Quake valves (MP4, MP4, MP4, MP4)This article has not yet been cited by other publications.

Accelerated refilling speed in rapid stereolithography based on nano-textured functional release film

Dynamics of Liquid Transfer from Nanoporous Stamps in High-Resolution Flexographic Printing

Rapid Prototyping of Soft Lithography Masters for Microfluidic Devices Using Dry Film Photoresist in a Non-Cleanroom Setting

Rapid vat photopolymerization through a superamphiphobic interface

Chemical Optimization Strategy of Rapid Additive Manufacturing via Up‐Conversion Assisted Photopolymerization Based Direct Ink Writing

Printing Depth Modeling, Printing Process Quantification and Quick-Decision of Printing Parameters in Micro-Vat Polymerization

Vat Photopolymerization Bioprinting with a Dynamic Support Bath

Multi-physics simulation and experimental study of the reaction kinetics process of oxygen inhibition zone formation in constrained-surface stereolithography process

Low Cost and Simple PMMA Nozzle Fabrication by Laser Cutting and PDMS Curing Bonding

High-resolution stereolithography using a static liquid constrained interface

Continuous DLP-based ceramic 3D printing using a composite oxygen-rich film

Rapid digital light 3D printing enabled by a soft and deformable hydrogel separation interface

A novel hybrid patterning technique for polymer PDMS micro and nanoscale nozzle by double casting

Air-Diffusion-Channel Constrained Surface Based Stereolithography for Three-Dimensional Printing of Objects With Wide Solid Cross Sections

Rapid Open‐Air Digital Light 3D Printing of Thermoplastic Polymer

Recombination between the postulated CCD/MHE/MHS locus and RYR1 gene markers

Syneresis‐Driven Self‐Refilling Printing of Geometry/Component‐Controlled Nano/Microstructures

High Resolution Soft Mold for UV-curing Nanoimprint Lithography Using an Oxygen Insensitive Degradable Material

Light-oriented 3D printing of liquid crystal/photocurable resins and in-situ enhancement of mechanical performance

Composite Elastomer-Enabled Rapid Photofabrication of Microfluidic Devices

Self-Driven, Monopolar Electrohydrodynamic Printing via Dielectric Nanoparticle Layer