Abstract:Purpose Recently, the constrained surface projection stereolithography (SL) technology is gaining wider attention and has been widely used in the 3D printing industry. In constrained surface projection SL systems, the separation of a newly cured layer from the constrained surface is a historical technical barrier. It greatly limits printable size, process reliability and print speed. Moreover, over-large separation force leads to adhesion failures in manufacturing processes, causing broken constrained surface and part defects. Against this background, this paper investigates the formation of separation forces and various factors that affect the separation process in constrained surface projection SL systems. Design/methodology/approach A bottom-up projection SL testbed, integrated with an in-situ separation force measurement unit, is developed for experimental study. Separation forces under various manufacturing process settings and constrained surface conditions are measured in situ. Additionally, physical models are constructed by considering the liquid resin filling process. Experiments are conducted to investigate influences of manufacturing process settings, constrained surface condition and print geometry on separation forces. Findings Separation forces increase linearly with the separation speed. The deformation and the oxygen inhibition layer near the constrained surface greatly reduce separation forces. The printing area, area/perimeter ratio and the degree of porousness of print geometries have a combined effect on determining separation forces. Originality/value This paper studied factors that influence separation force in constrained surface SL processes. Constrained surface conditions including oxygen inhibition layer thickness, deformation and oxygen permeation capability were investigated, and their influences on separation forces were revealed. Moreover, geometric factors of printing layers that are significant on determining separation forces have been identified and quantified. This study on separation forces provides a solid base for future work on adaptive control of constrained surface projection SL processes.

Air-Diffusion-Channel Constrained Surface Based Stereolithography for Three-Dimensional Printing of Objects With Wide Solid Cross Sections

Influence of Micro-Feature Parameters of a Constrained Substrate on Mass Transfer of Photopolymerization Inhibition Gas in Continuous Liquid Interface Production

High-resolution stereolithography using a static liquid constrained interface

Rapid Continuous 3D Printing Via Orthogonal Dual-Color Photoinitiation and Photoinhibition

Low Adhesion Continuous Constrained-Surface Projection Stereolithography Process Based on Curing Degree Control

Oxygen-controlled Bottom-Up Mask-Projection Stereolithography for Ceramic 3D Printing

Continuous liquid interface production of 3D objects

Interfacial Regulation for 3D Printing based on Slice‐Based Photopolymerization

Multi-physics simulation and experimental study of the reaction kinetics process of oxygen inhibition zone formation in constrained-surface stereolithography process

Study of separation force in constrained surface projection stereolithography

Continuous DLP-based ceramic 3D printing using a composite oxygen-rich film

High-resolution stereolithography: Negative spaces enabled by control of fluid mechanics

Vapor-induced phase-separation-enabled versatile direct ink writing

Continuous 3D Printing by Controlling the Curing Degree of Hybrid UV Curing Resin Polymer

Effect of Constrained Surface Texturing on Separation Force in Projection Stereolithography

Three-dimensional Printing of Large Objects with High Resolution by Scanning Lithography

Direct-write 3D printing of UV-curable composites with continuous carbon fiber

Achieving high geometric fidelity in vat photopolymerization additive manufacturing through liquid surface support

Growing three-dimensional objects with light

Light-oriented 3D printing of liquid crystal/photocurable resins and in-situ enhancement of mechanical performance

The Effect of Acceleration on the Separation Force in Constrained-Surface Stereolithography