Abstract:To accommodate the integration of renewable energy, coal-fired power plants must take on the task of peak regulation, making the low-load operation of boilers increasingly routine. Under low-load conditions, the phase transition point (PTP) of the working fluid fluctuates, leading to potential flow instability, which can compromise boiler safety. In this paper, a one-dimensional coupled dynamic model of the combustion and hydrodynamics of a supercritical boiler is developed on the Modelica/Dymola 2022 platform. The spatial distribution of key thermal parameters in the furnace and the PTP position in the water-cooled wall (WCW) are analyzed in a 660 MW supercritical boiler when parameters on the combustion side change under full-load and low-load conditions. The dynamic response characteristics of the temperature, mass flow rate, and the PTP position are investigated. The results show that the over-fire air (OFA) ratio significantly influences the flue gas temperature distribution. A lower OFA ratio increases the flue gas temperature in the burner zone but reduces it at the furnace exit. The lower OFA ratio leads to a higher fluid temperature and shortens the length of the evaporation section. The temperature difference in the WCW outlet fluid between the 20% and 60% OFA ratios is 11.7 °C under BMCR conditions and 7.4 °C under 50% THA conditions. Under the BMCR and 50% THA conditions, a 5% increase in the coal caloric value raises the flue gas outlet temperature by 32.7 °C and 35.4 °C and the fluid outlet temperature by 6.5 °C and 9.9 °C, respectively. An increase in the coal calorific value reduces the length of the evaporation section. The changes in the length of the evaporation section are −2.95 m, 2.95 m, −2.62 m, and 0.54 m when the coal feeding rate, feedwater flow rate, feedwater temperature, and air supply rate are increased by 5%, respectively.

Dynamic Heat Transfer Characteristics of Gas-solid in Medium Speed Mill

Influence of improving medium-speed pulverizer outlet temperature on the operation of boiler

Research on 1050MW Unit Bituminous Coal Boiler Blending Baiyinhua Lignite

Numerical Simulation Of Gas-Flow In Ball Mill

Study on the inner process of medium-speed pulverizer based on TG-FTIR and numerical simulation

NUMERICAL SIMULATION OF PRIMARY AIR MEASUREMENT AT THE INLET OF COAL MILL

Cold Model Test on Gas-Solid Two Phase Flow in Double Charge-Discharge Coal Ball Mill

NUMERICAL SIMULATION OF THE GAS FLOW IN THE BBD COAL BALL MILL

Simulation Study on Heat Transfer Characteristics of Coal Synthesis Gas Installations

Numerical and experimental investigations on the performance of a 300 MW pulverized coal furnace

Simulation of Heat and Mass Transfer in Pulverized Coal Boiler Based on Gaseous Combustion Through Phase Separation Technique

Optimal simulation on the combination mode of mills for an ultra-supercritical utility boiler

Cold Simulation Analysis of Flow Characteristics of High-Temperature Mixture in a Moving-Bed Reactor

Study on the deviation of outlet air velocity of powder feeding duct in power plant based on sudden tube expansion

Flow Behavior of High-Temperature Flue Gas in the Heat Transfer Chamber of a Pilot-Scale Coal-Water Slurry Combustion Furnace

Multiphase flow and reactor optimization of a 1MWth pilot-scale circulating fluidized bed for coal staged conversion

Three-dimensional simulation of gas-solid mixing behavior in thermal plasma reactor for coal pyrolysis

Simulation of Dynamic Characteristics of Supercritical Boiler Based on Coupling Model of Combustion and Hydrodynamics

Simulation of Heat and Mass Transfer in a Moving Bed Part-fluidized Boiler

Research on Pulverizer Rejects Characteristics for Medium Speed Mill

Coal Mill Model Considering Heat Transfer Effect on Mass Equations with Estimation of Moisture