Abstract:In this paper, we present a broadband out-of-phase power divider with high power-handling capability. The proposed device consists of several sections of double-sided parallel-strip lines (DSPSLs), a mid-inserted conductor plane, and two external isolation resistors, which are directly grounded for heat sinking. A through ground via (TGV), connecting the top and bottom sides of DSPSLs, is employed. The special metal via is realized to short the isolation resistors at full-frequency band when the odd-mode is excited. Meanwhile, it can be ignored as the excitation is even-mode. This property is efficiently utilized to improve the bandwidth. To examine the proposed power divider in detail, a set of closed-form equations are derived. Meanwhile, the power operation analysis illustrates that the proposed power divider is a good candidate for high power applications. The design charts show that the proposed device can support a wide frequency ratio range (1-1.7). Furthermore, broadband responses can be obtained when proper frequency ratios are adopted. For verification, an experimental power divider operating at 1.25/1.75 GHz is implemented. The measured results exhibit a bandwidth of 44.3% with better than 15 dB return loss and 18 dB port isolation is achieved.

Simulation and design of Ku-band Wilkinson power splitters

Design and Optimization of Broadband Polarization Beam Splitter Made from A Wave-Structured Multilayer Film

Design and Analysis of a Novel Broadband Tweaked T-shaped Stub-loaded Quadrature Power-Splitter

Mid-Infrared, Ultra-Broadband, Low-Loss, Compact Arbitrary Power Splitter Based on Adiabatic Mode Evolution

Development of a Compact X-band Variable-Ratio RF Power Splitter

Study and fabrication of multimode interference GaAs optical power splitter

DESIGN OF A COMPACT VARIABLE X-BAND RF POWER SPLITTER

Broadband Multimode 3 Db Optical Power Splitter Using Tapered Couplers.

Design of a Compact Variable Waveguide RF Power Splitter for High-Power Applications

Ultracompact And Wideband Power Splitter Based On Triple Photonic Crystal Waveguides Directional Coupler

Novel Design of Dual-Band Unequal Wilkinson Power Divider

A simple design of low-loss quad-band Wilkinson power dividers

Design and Measurement of a Six-Way Microwave Power Splitter with Good Phase Consistency

A tri-band Wilkinson power divider using extended T-shaped stubs

An improved wideband three‐way waveguide power divider based on directional coupler for Ku band application

Design of a Variable X-band RF Power Splitter

W-band Power Divider Based on H-plane Slot Waveguide Bridge

A BROADBAND OUT-OF-PHASE POWER DIVIDER FOR HIGH POWER APPLICATIONS USING THROUGH GROUND VIA (TGV)

Design and analysis of six-channel power divider with high power and low loss

Four-way Wideband Power Divider Using a Hybrid HMSIW/microstrip Line

Broadband Six-Way Out-Of-Phase Siw Power Divider