Abstract:For n-type PbTe based compounds with relatively low optimal concentration (10(19) cm(-3)), the accompanied structural defects play pivotal role on the charge transport upon doping with alien valent atoms. Herein, we report that Oxygen has huge influence on the defect evolution and thermoelectric properties in n-type PbTe for the first time. A boosted thermoelectric figure of merit ZT of similar to 1.12 at 673 K and a ZT(ave) of 0.84 in the range of 300-873 K are achieved for vacuum sintered Bi-doped PbTe with the powders ground under the protection of Ar. This is in sharp contrast with the same Bi-doped PbTe material sintered with the powders ground in the air, which reaches a ZT(ave) of 0.52. This distinct thermoelectric properties in Bi-doped PbTe compounds are strongly correlated to Bi dopant, the vacancy defects (V-Pb '' and V-Te(center dot center dot)) induced during the fracturing process, and oxygen in the air. The coexistence of Bi dopant and oxygen lowers the formation energy of Pb vacancies and induces large number of O-Bi related Pb vacancies in the structure, yielding an acceptor-like effect. Such negatively charged Pb vacancies in the structure exert a strong long-range coulombic repulsion force on the electrons, leading to a low doping efficiency, a low carrier mobility (200 cm(2) V-1 s(-1)), and inferior electronic properties. Whereas, the protection provided by Ar effectively avoids the contamination by oxygen and prevents the formation of O-Bi related Pb vacancies, which appears remarkably effective in enhancing the electronic transport. A high carrier mobility of 1300 cm(2) V-1 s(-1) is attained in slightly doped Pb0.9995Bi0.0005Te sample and this contributes to an ultra-high power factor of 40 mu W cm(-1) K-2 for the Pb0.9995Bi0.0005Te sample at room temperature. The high PFave exceeds 25 mu W cm(-1) K-2 in the range of 300-723 K. The work provides a new insight into the formation mechanism of structural defects and a new avenue for suppressing the cation vacancies, resulting in higher performance of n-type PbTe-based compounds.

Single-Layer Biobr: An Effective P-Type 2d Thermoelectric Material

High-Temperature Thermoelectric Monolayer Bi 2 TeSe 2 with High Power Factor and Ultralow Thermal Conductivity

High-Performance p-Type Bi 2 Te 3 -Based Thermoelectric Materials Enabled via Regulating Bi-Te Ratio

Monolayer enhanced thermoelectric properties compared with bulk for BiTeBr

A First-Principles Study of 2D Bi-Based BiOClBr, BiOClI, and BiOBrI Monolayers with Ultralow Lattice Thermal Conductivities for Thermoelectric Application

Bi8Se7: Delocalized Interlayer π-Bond Interactions Enhancing Carrier Mobility and Thermoelectric Performance near Room Temperature

The Thermoelectric Properties of Bismuth Telluride

High thermoelectric performance and anisotropy studies of n-type Mg3Bi2-based single crystal

Modulation Doping Enables Ultrahigh Power Factor and Thermoelectric ZT in n‐Type Bi 2 Te 2.7 Se 0.3

Synergistical Enhancement of Thermoelectric Properties in N‐type Bi2O2Se by Carrier Engineering and Hierarchical Microstructure

Comprehensive Insight into p -Type Bi 2 Te 3 -Based Thermoelectrics near Room Temperature

Synergistic Texturing and Bi/Sb‐Te Antisite Doping Secure High Thermoelectric Performance in Bi 0.5 Sb 1.5 Te 3 ‐Based Thin Films

Tunable Electrical Conductivity and Simultaneously Enhanced Thermoelectric and Mechanical Properties in n-type Bi<sub>2</sub>Te<sub>3</sub>

Thermoelectric performance of Bi2Sn2Te6 monolayer with ultralow lattice thermal conductivity induced by hybrid bonding properties: A theoretical prediction

Tunable Electrical Conductivity and Simultaneously Enhanced Thermoelectric and Mechanical Properties in n‐type Bi2Te3

High thermoelectric and mechanical performance in strong-textured n-type Bi2Te2.7Se0.3 by temperature gradient method

Synergistic Improvement of BiI3 and In on Thermoelectric Properties of Zone-Melted n-Type Bi2Te2.7Se0.3

Bismuth telluride compounds with high thermoelectric figures of merit

Enhanced High-Temperature Thermoelectric Performance by Strain Engineering in BiOCl

Substituted (P, As, Sb, S and Se) of two dimensional Bi2Te3 monolayer under stress at high temperature: achieving high thermoelectric performance

Avoiding Oxygen Induced Pb Vacancies for High Thermoelectric Performance of N-Type Bi-doped Pb1-xBixTe Compounds